Living & Co ALLEGRA Instructions

Please read these instructions and warnings carefully before operating to ensure safe
Warnings:
This is a Class II product and does not require an earth connection.
•
The light fitting incorporates an integrated LED lighting strip, the LED lighting cannot be
•
replaced, do not attempt to remove.
Do not cover the lamp fitting during use as this could be a potential safety hazard.
•
The luminaire is not intended for use by children unless suitable adult supervision is
•
provided.
Children should be supervised to ensure they do not play with the luminaire.
•
The fitting is intended for indoor use only.
•
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively
•
replaced by a suitably qualified person in order to avoid a hazard.
• Only use the light fitting in conjunction with the AC power supply adaptor provided.
• Do not locate the light fitting in a high heat or high humidity environment.
• Ensure supply cables are not pulled taut and are located to avoid trip hazards.
Assembly:
1. Remove protective plastic overwrap and packaging from the lamp fitting.
2. Carefully place the light fitting on its side and align the holes in the underside with
the holes in the base provided.
3. Insert the retaining screws through the underside of the base and into the light
fitting, tighten to secure the two parts together. Ensure the countersunk screws
are tightened flush with the underside of the base.
4. Place the lamp fitting on a stable / dry and level support surface.
5. Connect the plug from the output lead of the AC power supply adaptor into the
corresponding socket at the rear of the light fitting.
6. Insert the AC power supply adaptor plug pins into a mains socket outlet and
switch on.
MARKETED BY: The Warehouse, 26 The Warehouse Way, Northcote, Auckland 0627 - Phone: 0800 422274
Living & Co
ALLEGRA LED FLOOR LAMP
Instructions
and satisfactory operation of this product.
Please also retain these instructions for future use.