Download Print this page

Siemon VersaPOD Assembly

Frame kit

Hide thumbs Also See for VersaPOD:

Download this manual

Required Tools

10mm Wrench

13mm Wrench

24mm Wrench

T30 Torx Driver

1-1

1-2

Gather six horizontal brackets [2] and twelve torx M6-12 screws [3]. Assemble brackets to middle of frame

as shown to 77-83 in-lbs of torque.

1-3

Gather two horizontal frames [4] and four torx M6-12

screws. Assemble horizontal frame as shown on both top

and bottom to 77-83 in-lbs of torque.

VersaPOD

- Frame Kit Assembly

Gather one vertical frame [1].

x12

Keyway Must Face

Toward Bottom

Need help?

Do you have a question about the VersaPOD and is the answer not in the manual?

Page 1 ® VersaPOD - Frame Kit Assembly Required Tools 10mm Wrench 13mm Wrench 24mm Wrench T30 Torx Driver Gather one vertical frame [1]. Keyway Must Face Toward Bottom Gather six horizontal brackets [2] and twelve torx M6-12 screws [3]. Assemble brackets to middle of frame as shown to 77-83 in-lbs of torque.
Page 2 Insert six leveling feet [5] into designated holes on bottom of cabinet frame. Install the 2nd vertical frame with fourteen torx M6-12 screws. Assemble to frame as shown to 77-83 in-lbs of torque. If installing castors, please follow step 1-6. If not, please proceed to step 1-7 Gather four Caster assemblies [6] and 16 M6 nuts [7].
Page 3 One plate on Bottom View each end Carefully raise cabinet to standing position. Gather base cover plate [9] and assemble to NOTE: Two operators are frame as shown using one M6-12 torx required to lift and move Gather cover, four M6 nuts . Assemble cover [8] onto frame as screw.
Page 4 ® VersaPOD - Side Panel Assembly VP1(A/B) Repeat Steps 2-1 Side Panels Side Panel Assembly and 2-2 for each Steps 2-1 to 2-4 VP1A side panel NOTE: If side panels Lock each are not required, top latch skip to Section 3...
Page 5 ® VersaPOD - Door Assembly Full Door Assembly Split Door Assembly Rod mates with bushing x 4 Rod mates with bushing x 8 Gather one full door [16]. Remove keys, Gather split doors [17]. Assemble to frame as shown. Gather branding plate [18], four acorn nuts [19] and if attached to the door and place them four M6-32 screws [20].