Teknik VISION User Manual

[VISION]
LED FLOODLIGHT
USER MANUAL
Teknik Lighting Solutions Pty Ltd | ABN: 44 608 397 913 | www.tekniklighting.com.au
INTRODUCTION
Please ensure that the luminaire is installed in accordance with the below instructions. Teknik Lighting
Solutions Pty Ltd assumes no responsibility for inappropriate use or installation of the product,
including any associated damage caused.
PRECAUTION
1. Read the entire manual carefully before
installation and operation.
2. The Warranty Period is listed on the
product and the packaging. Teknik will
repair or replace the product if it fails or
becomes defective during normal use
within the prescribed warranty period.
3. Designed for industrial and commercial
use.
4. The lifetime of the product is affected when
it is used in a fully enclosed fixture.
5. Installation must be performed by a
licenced and qualified electrician.
6. Use solid copper wire of 18 AWG
(minimum) for the input terminal extension,
and 20 AWG (minimum) for the output
terminal extension.
7. Do not change or tamper with any internal
electric circuits or wiring, connectors or
cables for any reasons.
8. Do not insert foreign objects into the
product. This may result in electric shock,
malfunction or damage to the products.
9. When in operation the luminaire
temperature may reach up to 45°C.
DISCLAIMERS
1. This product must be installed and used as
per these instructions.
2. This product contains no serviceable
parts and no attempt should be made to
repair this product. If the product is faulty it
should be discarded.
3. This product is not suitable for installation
in hazardous and/or corrosive areas.
4. Electrical installations periodically receive
transient over voltages. This product has
been designed to minimise the effect of
5/26-34 Dunning Ave, Rosebery NSW 2018
10. Teknik accepts no liability for any injuries or
damages resulting from the incorrect use of
the lamp or use of the lamp in combination
with inappropriate equipment.
11. This luminaire is dimmable using 1-10V
or PWM type dimming systems. The use
of other dimming protocols could cause
damage to the luminaire and will void any
warranties.
12. This product has no user serviceable parts.
If any part is damaged, disconnect from
mains and discontinue use.
13. In case of weight discrepancy when
replacing old lamps, please ensure that
the mounted structure is rated to withstand
the weight of the new lamp and installation
materials.
14. Do not cover the light.
15. The warranty shall exclude modifications to
the product, incorrect installation and use
outside of the intended scope.
16. For further information, please contact
Teknik Lighting Solutions or your local
distributor.
such voltages on connected equipment.
It may not give full protection for extreme
over-voltage transients such as those
resulting from a close lightning strike.
5. This product utilises intellectual property in
the form of registered designs, trademarks,
and/or patents. Such intellectual property
remains the property of Teknik Lighting
Solutions Pty Ltd in all cases.
6. This product has been designed to operate
in ambient temperatures -40 o C to + 50
| 1300 313 780 | info@tekniklighting.com.au
o C.
1