Electronics Line EL-2614E Instruction Manual

Figure 1: EL-2614E/
Figure 1: EL-2614E/
Figura 1: EL-2614E
Battery Replacement
If the LED blinks during transmissions, this indicates
that the battery is low and need replacing.
To replace the battery:
1. Insert a small screwdriver into the pry-off
slot – see Figure 2. Carefully twist the
screwdriver to separate the front and back
of the casing.
2. Observing correct polarity, replace the battery.
3. Close the casing making sure that the front
and back click shut.
Technical Specifications
Antenna: Built-in whip
Frequency: 868.35, 433.92, or 418 MHz FM
Power: 3V Lithium Battery, Size CR2032
Caution: Fire, explosion and severe burn hazard! Do not
recharge, disassemble or heat above 100°C (212F).
Current Consumption:
20mA (transmission),
2µA (standby)
RFI Immunity: 40V/m
Operating Temperature: 0-60°C
Dimensions: 62x42x15mm
English
The EL-2614E is a four-button keyfob transmitter designed for use
with Electronics Line 3000's supervised wireless range of receivers.
Registration
To register the EL-2614E:
1. Set the receiver to Registration mode.
2. Press one of the buttons, making sure that the LED lights
up when the button is pressed.
3. Wait for five seconds and press the same button again.
Alternatively, the EL-2614E can be registered to the receiver
by manually entering the transmitter's serial number.
EL-2614E
Figure 2: Opening the casing/
Figure 2: Ouverture du boîtier/
Figura 2: Abriendo la tapa
Battery Holder/
Emplacement de
la Batterie/
Soporte de
la Batería
Figure 3: Rear view (casing open)/
Figure 3: Vue arrière (boîtier ouvert)/
Figura 3: Vista posterior (tapa abierta)