Shark S1000A Instructions

Please read this manual carefully before operating your unit
NOTE: Accessories may vary depending on
the model. Refer to quick guide, if available.
The images shown here are for illustrative
purposes only and may be subject to change.
ASSEMBLING YOUR STEAM MOP
A
804109277A
WARNING: ALWAYS
make sure the Steam
Mop is UNPLUGGED
when not in use.
NEVER fill the
Steam Mop when it is
plugged into an
electrical outlet.
Unplug from the
electrical outlet and
allow the unit to cool
before you fill the
water tank, or attach
or remove the mop
head. Make sure you
add only water to
the tank. Chemicals
or cleaning solutions
(including vinegar)
may damage the
Steam Mop and could
be unsafe for you and
your family.
STEP1
STEP2
1 Align the mop handle and mop pole so the arrow symbols
inside them face forward. Insert either end of the pole into
the handle until it clicks securely into place.
2 Align the assembled steam mop pole and the steam mop
body, so their arrow symbols both face forward. Insert the
pole into the top of the mop body, sliding it in until it clicks
into place.
3 Place the Dirt Grip'" cleaning pad on the floor with the
quick fastener strips facing up. Align the mop head directly
over the pad, then press the mop head down onto the pad.
The quick fastener strips will secure the pad to the mop
head.