Sparkfun Electronics SparkPNT GNSSDO Quick Start Manual page 8

GETTING STARTED
Connect Using Ethernet
either the CONFIG MOSAIC or the CONFIG ESP32 USB-C
port. It does not matter which. You should see the red
power (PWR) LED light up and text start to appear on the
OLED display.
Once the mosaic-T has acquired a satellite signal and is
connected to the Ethernet network, the OLED will display:
the antenna's position as Latitude (Lat), Longitude (Long);
the Ethernet IP (Internet Protocol) network address; and
other information.
4. Connect your computer, tablet or phone to the same
network, open a web browser and navigate to the IP
address shown on the OLED display. You should see the
mosaic-T's internal web page. The web page displays a lot of
helpful information and can also be used to fully configure
the mosaic-T.
docs.sparkfun.com/SparkFun_GNSSDO
2