Hatco AMERICAN RANGE ARMG Owner's Manual And Installation

OWNER'S MANUAL, INSTALLATION, USE AND CARE
ARMG, ARSMG, ARSTG, ARTG, AEMG, AETG, ARGB, ARTY, ACCG,
BEFORE USING YOUR APPLIANCE, PLEASE READ THIS MANUAL, PAYING SPECIAL ATTENTION
TO THE IMPORTANT SAFETY INSTRUCTIONS LOCATED IN THE NEXT SEVERAL PAGES
Improper installation, adjustment, alteration, service, or maintenance
can cause property damage, injury, or death. Read the installation,
operating and maintenance instructions thoroughly before installing
or servicing this equipment.
IMPORTANT – PLEASE READ AND FOLLOW!
Instructions to be followed in the event the user smells gas must be posted in a prominent location.
This information must be obtained by consulting the local gas supplier.
CAUTION
Check your local building codes for proper installation methods. In the absence of local codes, this appliance must be installed in
accordance with the National Fuel Gas Code No. Z223.1 current issue, and the National Electrical Code ANSI/NFPA No. 70 current
issue, or the CAN – B149 Installation Codes for Gas Burning Appliances, and C22.1 Canadian Electrical Code Part 1.
Verify the type of gas supplied to the location, being sure that the appliance is connected to the type of gas for which it is certified.
Models come from the factory certified for use with Natural Gas (NG) or Liquid Propane (LP) gas. Your product, shown on the rating
label and the supplied gas type must be the same. Upon opening your product, the rating label can be located on the front panel. If it
is a countertop, the rating label can be found on the rear panel.
If connecting this appliance to propane gas, make certain the propane gas tank is equipped with its own high-pressure regulator – in
addition to the pressure regulator supplied with this product when applicable. The maximum propane gas pressure to this appliance
must not exceed 14.0 inches of water column (34.9 millibar) from the propane gas tank to the pressure regulator.
INSTALLATION, OPERATION AND
SERVICE PERSONNEL
Installation of the equipment should be performed by qualified,
certified, licensed and/or authorized personnel who are experienced
in state/local installation codes. Have the technician show you the
exact location of the gas shut-off valve on the incoming gas line so
you know how to turn off the gas if necessary.
Operation of the equipment should be performed by qualified or
authorized personnel who have read this manual and understand
and are familiar with the functions of the equipment.
Service of the equipment should be performed by qualified
personnel who are knowledgeable with American Range products.
COUNTERTOP GRIDDLES
WARNING!
RETAIN THIS MANUAL FOR FUTURE REFERENCE
This equipment is design engineered for commercial use only.
FOR YOUR SAFETY
Do not store or use gasoline or
other flammable vapors and liquids
in the vicinity of this or any other
appliance.
DANGER
1. A manual gas shut-off valve must be installed in the
gas supply (service) line ahead of the appliance and gas
pressure regulator in the gas stream for safety and ease
of future maintenance/service.
2. The gas pressure regulator supplied with the appliance
must be installed prior to connecting the equipment
to the gas supply line. Failure to install a regulator will
void the equipment warranty and result in a potentially
hazardous condition.
3. Please contact the factory, a factory representative,
or local service company to perform maintenance and
repairs.