Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Mitsubishi Electric Mr.SLIM MSY-XZ09VFW
Summary of Contents for Mitsubishi Electric Mr.SLIM MSY-XZ09VFW
- Page 1 SPLIT-TYPE AIR CONDITIONERS INDOOR UNIT MSY-XZ09VFW MSY-XZ13VFW MSY-XZ09VFB MSY-XZ13VFB For user OPERATING INSTRUCTIONS English • To use this unit correctly and safely, be sure to read these operating MSY-XZ18VFW instructions before use. MSY-XZ18VFB...
- Page 2 ONTENTS ■ SAFETY PRECAUTIONS ■ NAME OF EACH PART ■ PREPARATION BEFORE OPERATION ■ SLEEP OPERATION ■ MOVE-EYE OPERATION ■ SELECTING OPERATION MODES ■ FAN SPEED AND AIRFLOW DIRECTION ADJUSTMENT ■ AIRFLOW CONTROL MODE ■ ABSENCE DETECTION ■ FAST COOLING A.I. OPERATION ■...
-
Page 3: Safety Precautions
AFETY PRECAUTIONS Never put batteries in your mouth for any reason to avoid WARNING accidental ingestion. • Battery ingestion may cause choking and/or poisoning. Before cleaning the unit, switch it OFF and disconnect the • This may cause injury, since the fan inside rotates at high power plug or turn the breaker OFF. -
Page 4: Indoor Unit
AME OF EACH PART Indoor unit Remote controller Heat exchanger Signal transmitting section Distance of signal : Front panel Air inlet About 6 m* from the indoor unit when the signal is received. * Refer to page 13 Operation display for ERROR CODE section DISPLAY MODE. -
Page 5: Preparation Before Operation
REPARATION BEFORE OPERATION Before operation: Turn on power supply and/or turn the breaker on. Setting the installation position Be sure to set the remote controller in accordance with the installed position of the indoor unit. Installing the remote controller batteries Press RESET. -
Page 6: Sleep Operation
LEEP OPERATION OVE-EYE OPERATION A user can select a desired mode from WIDE ROOM, SLEEP, or QUIET. In the move-eye control mode, the room temperature is controlled based on the sensible temperature. Press during COOL mode page 6 to start SLEEP operation. -
Page 7: Selecting Operation Modes
ELECTING OPERATION MODES I FEEL mode The unit selects the operation mode according to the room temperature when I FEEL is selected. When the room temperature is higher than 25°C, lower than 25°C, DRY is selected. However, when operation is stopped and then started within 2 hours, the mode which has been selected previously is operated. - Page 8 AN SPEED AND AIRFLOW DIRECTION ADJUSTMENT Left-right Airflow direction Press (SWING Press (SWING Fan speed Press to select fan speed. Each press changes fan speed in the following order: • Two short beeps are heard from the indoor unit when set to AUTO. •...
- Page 9 IRFLOW CONTROL MODE BSENCE DETECTION This function automatically changes the operation to No occupancy an occupant in a room detected by move-eye Sensor. energy-saving mode or No occupancy Auto-OFF mode when nobody is in the room. Press during COOL, DRY or I FEEL mode to To activate this No occupancy energy-saving mode, activate the AIRFLOW CONTROL mode.
- Page 10 AST COOLING A.I. OPERATION Press again to cancel the FAST COOLING A.I. operation. • There may be a temporary difference between the remote controller display and the operation of the air conditioner. • The FAST COOLING A.I. operation is also canceled when MODE, OFF/ON, FAN, VANE, DIRECTION or ON TIMER is pressed.
-
Page 11: Emergency Operation
IMER OPERATION (ON/OFF TIMER) MERGENCY OPERATION When the remote controller cannot be used... Emergency operation can be activated by pressing the emergency operation Each time the E.O. SW is pressed, the operation changes in the following order: Operation indicator lamp Emergency COOL Stop Set temperature : 24°C... -
Page 12: Front Panel
LEANING Instructions: • Do not use a scrubbing brush, or hard materials for cleaning, as they may • Be careful not to touch the metal parts with your hands. cause damage to the components or equipment. • Do not use benzine, thinner, polishing powder, or insecticide. •... -
Page 13: When You Think That Trouble Has Occurred
HEN YOU THINK THAT TROUBLE HAS OCCURRED Symptom Explanation & Check points Even if these items are checked, when the unit does not recover from the trouble, stop using the air conditioner and consult your dealer. Does not cool The room cannot be cooled •... - Page 14 RROR CODE DISPLAY MODE Error code can be checked on the display of remote Error code of remote controller controller while the operation indicator lamp on the indoor unit is blinking. Object Code Abnormal point Follow the procedure below to check the error code. Indoor unit Serial signal Indoor control system...
-
Page 15: Electrical Work
HEN THE AIR CONDITIONER IS NOT NSTALLATION PLACE AND GOING TO BE USED FOR A LONG TIME ELECTRICAL WORK Installation place Operate by COOL mode with the highest temperature Avoid installing the air conditioner in the following places. set or FAN mode for 3 to 4 hours. Page 6 •... - Page 16 ■ ■ ■ ■ ■ move eye ■ ■ ■ ■ move eye ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ • • • • • Th-1...
- Page 17 • • • • • • • • • • • • • • • • • • Th-2...
- Page 18 • Th-3...
- Page 19 • • • • • • • • • Th-4...
- Page 20 • • • Th-5...
- Page 21 ° ° ° ° ° (I FEEL) (COOL) (DRY) (FAN) ° • Th-6...
- Page 22 • Th-7...
- Page 23 (INDIRECT) (DIRECT) (EVEN) Th-8...
- Page 24 • • • • • • • • DIRECT SWING INDIRECT • • • • • • Th-9...
- Page 25 <XZ09/13> <XZ18> ° • Th-10...
- Page 26 ° • • • • • • MAC-1001CL-E • • • • XZ09/13: MAC-EMF815FT-E XZ09/13: MAC-2320FT MAC-EMF925FT-E MAC-2321FT XZ18: MAC-EMF115FT-E XZ18: MAC-2310FT-E MAC-EMF125FT-E MAC-2410FT-E • • • Th-11...
- Page 27 • • Th-12...
- Page 28 Th-13...
- Page 29 MSY-XZ09VF MSY-XZ13VF MSY-XZ18VF ° ° — ° ° ° — ° Th-14...
- Page 32 HEAD OFFICE: TOKYO BUILDING, 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN VG79Y892H01...
Need help?
Do you have a question about the Mr.SLIM MSY-XZ09VFW and is the answer not in the manual?
Questions and answers