Integra Dormer Rod Fitting Instructions

Fitting Instructions
Please read these instructions carefully and check the
contents of the pack against the table below before
attempting to assemble and install this product. Please
ensure the correct wall plugs are used to suit your wall
type, if unsure consult your local DIY store.
DO NOT over reach. Always move the step ladder so that you are in a safe working position.
Take care when using power tools, use of a Residual Current Device (RCD) is recommended.
Always use eye protection when drilling. Beware of hidden pipe runs and cables.
No liability will be accepted for damage or injury caused by incorrectly installed or assembled product.
PLEASE KEEP OUT OF THE REACH OF YOUNG CHILDREN. SMALL PARTS - CHOKING HAZARD.
PLEASE KEEP THESE INSTRUCTIONS AND THE BATCH CODE ON THE PACKAGING FOR FUTURE
Dormer Rod
Length
110cm
Safety Recommendation
Always use a step ladder when working at height.
DO NOT hold or lean on the rod to support your weight.
We recommend you use two people for installation of a larger rods.
REFERENCE IN CASE OF ANY QUERIES.
Should any component be missing, please call the
Customer Care Department on 0330 005 2233.
Tools required: Pencil, measure, spirit level, drill,
screwdriver, hacksaw and file (if cutting down).
Dormer Rod Bracket with
with Ball Finial
1
Fixings
1
7852L--02