Dell Dimension 4500 Owner's Manual page 81

NOTICE: To avoid damage to the drive, do not set it on a hard surface.
Instead, set the drive on a surface, such as a foam pad, that will sufficiently
cushion it.
Check the documentation for the drive to verify that it is configured
1
for your computer.
Perform an orderly computer shutdown using the operating system
2
menu.
Turn off your computer and any devices.
3
Ground yourself by touching an unpainted metal surface on the
4
chassis, such as the metal around the card-slot openings at the back of
the computer, before touching anything inside your computer.
While you work, periodically touch an unpainted metal surface on the
computer chassis to dissipate any static electricity that might harm
internal components.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
Disconnect your computer and devices from their power sources. Also,
5
disconnect any telephone or telecommunication lines from the
computer.
Disconnect the computer power cable from the wall outlet, and then
6
press the power button to ground the system board.
Open the computer cover (see page 66).
7
Remove the two green plastic rails from the inside of the hard-drive
8
bay by gently pulling the rails up and out of the bay.
Attach the rails to the hard drive using the two screws attached to the
9
rails.
Ensure that the rail tabs are positioned at the back of the hard drive.
NOTICE: Do not install any drive into the lower hard-drive bay until you have
removed the green drive rails from the inside of the hard-drive bay.
Remove the first hard drive from the upper bay and install it in the
10
lower bay:
Disconnect the power and the hard-drive cables from the back of
a
the first hard drive.
81
Adding Pa rts