Page 1
Technical Support and E-Warranty Certificate www.vevor.com/support OPTICAL ELECTRIC MOTORIZED TABLE MODEL:WZ-3A We continue to be committed to provide you tools with competitive price. "Save Half", "Half Price" or any other similar expressions used by us only represents an estimate of savings you might benefit from buying certain tools with us compared to the major top brands and does not necessarily mean to cover all categories of tools offered by us.
Page 3
This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there are any technology or software updates on our product.
Warning - To reduce the risk of injury, the user must read the instructions manual carefully. SAFETY INSTRUCTIONS 1. General safety information for the use of electrical devices: To avoid injury from or electric shock, please ensure compliance with safety instructions when using this device.
Page 5
FCC Information CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment! This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This product may cause harmful interference.
PARTS LIST NOTE: Please check you have all the parts as shown in the part list. Table Plate x1 Column Assembly x1 Square&wheel Assembly x2 Bottom Drawer x1 Eye Mask x1 Hex Key x1 Plastic End Plug x4 Power Cord x1 Screw Washer x4 User Manual x1...
INSTALLATION A. Install the two tripods with casters in the boxes on the both sides of the elevator base respectively and tightening them. B. Tight the table plate with four M8(With the washer) inside Hexagon screw on the support board. C.
d) Inspection machines and table control switch plug is inserted in place. ③Slow rise and fall. (You are advised to contact professional maintenance personnel.) a) Check that the voltage used is correct - if the voltage is normal, the starting capacitor can be replaced with a 10-12UF capacitor according to the motor parameters.
Page 12
Technical Support and E-Warranty Certificate www.vevor.com/support...
Need help?
Do you have a question about the WZ-3A and is the answer not in the manual?
Questions and answers