Belkin SPORTCOMMAND FOR IPOD User Manual page 5

Operating Instructions
Connect any pair of headphones or speakers to the
iPod via the 3.5mm headphone port. Place the iPod
and Receiver into your pocket or backpack, using a
case for extra protection.
You can also keep your iPod stationary with a stereo
or boom box and remotely control up to 50 feet.
Simply connect a 3.5mm audio cable from the iPod
to the line-in port on a stereo receiver or speakers.
Attach the Remote to the VELCRO® patch on the
armband with the control panel facing up (Fig. 4).
Place the armband around your arm. Use the included
extension to improve your fit, if necessary (Fig. 5).
If you prefer to wear the remote on your belt,
backpack, or attached to another object, use the
included carabiner clip. Simply guide it through
the loop on the back of the Remote (Fig. 6).
You can now use your SportCommand Remote to
control the iPod device's play/pause, skip-forward,
skip-backward, and volume up/down functions while
your iPod stays protected at all times. We recommend
engaging the hold switch on the iPod to avoid
accidentally initiating the iPod controls.
Operating Instructions | 06
6-7
Operating Instructions
Automatic Sleep Mode
If there is no key press for 30 seconds, the Transmitter will automatically go into sleep
mode. The Transmitter will wake up with the next key press but it will not transmit
the signal to the Receiver. The Transmitter will function for the subsequent key press.
Note: Shuffle and repeat controls are not compatible with iPod 3G models (10GB, 15GB, 20GB, 30GB, 40GB). When used
with the iPod with color display, SportCommand lets you scroll through your slideshows or presentations—wirelessly.
Fig. 4
Water-Resistant Design
The SportCommand Remote features a water-resistant, hand-washable design.
Water beads off the surface of the Remote and cannot damage its functionality.
However, the Remote is not submergible.
Avoid using it during water-submersion activities such as swimming, surfing
and bathing. The Remote can be cleaned by hand with a little soap and water.
LED Chart
Fig. 5
Every time you push a button on the Remote, the green lights on the Remote
will blink, indicating that the signal has been received correctly. Shield the
Remote from direct sunlight to improve legibility of the LED.
The Remote's battery level is automatically checked after every button press.
If the battery level is low, the Remote's red light blinks once on each button press.
The low battery should be replaced soon. The SportCommand will continue to
function normally until the battery is exhausted.
Fig. 6
EN
Operating Instructions | 07 | 07
5/12/06 11:53:05 am