N52te USER MANUAL
Software Installation
1. Insert your n52te Installation CD into your CD/DVD drive on your
computer.
2. The software should start automatically. If it does not, click the "Start"
button and choose "Run". Click "Browse" and choose your CD drive.
Select "setup.exe" and click "OK".
3. Follow the on-screen instructions to continue with the software
installation.
4. After the installation is done, select "Finish". Connect the n52te to an
available USB port on your computer.
5. Once installation is completed, please check to see if the installation
was successful by proceeding to "Installation Verification".
Installation Verification
1. You will need to confirm that the installation was successful through
the Device Manager.
2. To get to Device Manager, right-click on "My Computer" and
left-click on "Properties". Then left-click on "Hardware" and then
on the "Device Manager" button.
3. Check to make sure that the Device Manager list includes:
a) Two new entries under Human Interface Devices, "Nostromo
n52te HID SpeedPad 2.0" and Nostromo n52te HID SpeedPad 2.0
Mouse Wheel".
b) A new entry under Keyboards, "HID Keyboard Device".
c) A new entry under Mice and Other Pointing Devices,
"HID-Compliant Mouse".
CONFIGURING n52te
n52te Editor
The n52te Editor is the tool used to create and customize profiles. A
profile is a set of remapped button functions that can be saved and
recalled at a later time.
Some examples of the type of actions you can program are:
Single Key – Make a button on the controller work like a keyboard key.
Macros – Record a sequence of keyboard keystrokes, mouse-button
presses, and/or joystick commands (such as axis controls, d-pad con-
trols, and joystick button commands) to be played back when a button
is pushed.
Keymap Selector – Switch between the three color Keymaps (Blue,
Green, Red) and effectively triple the number of functions you can
program in a single profile. The default Keymap is Blue.
Mouse – Program the game controller to function as a mouse click or
scroll wheel.
Polling Rate - Sets the polling rate to: 125Hz (8ms), 500Hz (2ms) or 1000Hz
(1ms). Note that any change to the polling rate will only take effect
after you reboot your computer.
Note: You would reduce the polling rate if your computer does not
support USB 2.0.
Razer Synapse™ - Store one of your profiles in the onboard memory to
take it with you! The profile stored with Razer Synapse will be available
on any PC, even without the software installed.
Page
1