These instructions can be out of reach of children. as it can cause burns and scalds. of kitchen work surface or touch hot downloaded from the Tommee Tippee® Appliances can be used by persons with surfaces. Use in a well-ventilated area.
Page 3
Water level low with Slow Flow Teat Removable water jug Jug temperature warning 1 x Milk Storage Lid Water outlet Bluetooth pairing 1 x Tommee Tippee® Bottle stand Power button Anti-bacterial Water Filter Drip tray Setting dial in fluid ounces...
Press and hold both 4fl oz and 11fl oz buttons at the same time for 2 seconds. The Tommee Tippee® app is available to download on Android and iOS app stores. Bluetooth pairing Press and hold bluetooth button (M) to reset bluetooth connection.
Cleaning cycle You must run a cleaning cycle BEFORE first use or when indicated by the cleaning icon. This can take up to 10 minutes to complete. DO NOT fit your filter until instructed to do so. 1 litre DO NOT REMOVE THE WATER JUG WHILE WATER IS BEING DISPENSED.
Page 6
Priming your filter Make sure that any air bubbles or loose particles are removed from the filter BEFORE USE by submerging it in water for at least 5 minutes. This is necessary to enable water to pass through the filter once it is installed in the machine.
You must run a cleaning cycle when replacing your filter. See Cleaning Cycle instructions. Your unit comes with a Tommee Tippee® Antibacterial Filter which lasts approximately 3 months (150 litres of water). If you use your water jug for daily water consumption in your household (outside of the machine) you should change your Tommee Tippee®...
Page 8
Filter replacement Fill filter hopper (C) to the maximum Place the lid (A) on the water jug Prime your filter by submerging Insert filter into the filter hopper level. (D) and add to your Perfect Prep® upright it in a bowl of cold tap water. and insert filter hopper (C) into machine.
Page 9
Preparing a bottle If you need to stop dispensing hot or cold water, press the Power button (N) for 2 seconds. Discard your feed and start the bottle preparation again from step 1. The unit is ready to be used again when the Power button medium high...
Page 10
Preparing a bottle FOR SAFETY, ADD THE COLD WATER WITHIN 2 MINUTES AFTER ADDING THE HOT SHOT. IF YOU TAKE LONGER THAN 2 MINUTES OR IF YOU STOP THE CYCLE, THE POWER BUTTON WILL ILLUMINATE WHITE. DISCARD THE FEED AND REPEAT THE BOTTLE PREPARATION PROCESS FROM STEP 1.
Page 11
Descaling your Perfect Prep® The descaling process will remove deposits of calcium and other minerals in the system that may affect its performance. The ‘calc’ or descaling icon (J) 500ml will illuminate when the unit requires descaling soon. If the light flashes, you should descale immediately.
Solid orange light on filter Its time to think about replacing your filter. Order a new filter from the Tommee Tippee® app or visit our replacement icon. website (tommeetippee.com) Flashing orange light on filter The Perfect Prep®...
Troubleshooting Icon Issue Possible cause Solution Solid orange light on cleaning icon. Your Perfect Prep® needs to be cleaned. Follow the Cleaning Cycle instructions. Solid orange light on water level The water level in the water jug is too low. Ensure you have enough water in the water jug.
Need help?
Do you have a question about the PerfectPrep Formula Feed Maker and is the answer not in the manual?
Questions and answers