Safety Precautions Age Recommendation; 14 years and up. This is not a toy. As the owner of this airplane, you are responsible to make sure that injury to others or damage to property is avoided. Make sure that you are familiar with the entire instruction manual before operation. Battery Warnings property damage! •...
Charging Instructions Red LED on while charging 1. Unplug the battery from your plane. LED off when done charging 2. Plug the charger into the USB port on your computer or USB adapter. 3. Connect battery to the charger. 4. The charging process will take up to 1 hour.
Transmitter Layout LED Indicator PASS Switch One-key Stunt Button Elevator Trim Elevator Trim Rudder Trim Aileron Trim Centering Control Surfaces With the transmitter turned on and the battery conected to the ESC (and installed in the battery compartment), it is now possible to check the center of all control surfaces. Check that the rudder is properly centered as shown above.
Page 5
Center Control Surfaces (cont.) Push Rod Arc-shaped Section Push Rod Arc-shaped Section If the rudder is not properly centered, If the elevator is not properly centered, adjust the push rod length by bending the adjust the push rod length by bending the arc-shaped section slightly with needle arc-shaped section slightly with needle nose pliers until the rudder is centered.
Digital Trim Digital trims allow you to adjust the center position of aileron, rudder, or elevator. Each time the trim button is pressed, the Elevator Trim servo output will change slightly. If the trim button is held, the output will scroll in that Rudder direction until the trim button is released or Trim...
Page 7
Stunt Function Button The stunt button allows the pilot to perform a roll One-key Stunt Button assist mode. As shown in the below diagrams, stunt button on the left shoulder of the transmitter and you will hear several beeps. While the transmitter is beeping, simply move the aileron stick to either direction for auto-roll or move the elevator stick to "up elevator"...
The prop saver keeps the propeller and prop shaft from damage, along with preventing the electronic components from over current. When the airplane hits any obstacle, the prop will pop loose and fall from the base. To reinstall the prop, center the prop adapter(see diagram) on the motor shaft, and press until you hear a "click"...
Page 9
Replacing Motor or Control Board The control board and motor can be accessed by removing the hatches on the bottom Screws Screws Use the following steps to replace the Control Board 1. Remove the screws as shown above and remove the arms. 2.
Flight Checklist IMPORTANT NOTE: Although this section can be used as a quick start guide, we strongly suggest that you read the entire manual before proceeding. This checklist is NOT intended to replace the content included in this instruction manual. - Ensure the throttle control stick is at bottom position before connecting the battery.
Limited Warranty Warranty Period: Rage R/C warrants that the Warbird Series (“Product”) will be free from original factory defects in materials and workmanship upon purchase (“Warranty Period”). What is Not Covered - This warranty is not transferable and does not cover (a) cosmetic damage, (b) damage due to acts of God, accident, misuse, abuse, negligence, commercial use, or due to improper use, installation, operation or maintenance, (c) Rage R/C authorized service center, or (e) Product not purchased from an authorized...
Need help?
Do you have a question about the MICRO WARBIRD MESSERSCHMITT Bf 109 and is the answer not in the manual?
Questions and answers