Related Manuals for Lotus LT255MTX
Summary of Contents for Lotus LT255MTX
- Page 1 ™ P e r f o r m a n c e , D e l i v e r e d . MIG Welder Made in China/Fabriqué en Chine Lotus Tool Group (Philippines) www.lotustools.ph LT255MTX...
-
Page 2: Safety Information
8 FOR ADDITIONAL PROTECTION FROM ELECTRICSHOCK It is recommended that this tool be used in conjunction with a residual current device(RCD) with a rated residual current of 30mA or less. Lotus Tool Group ®... - Page 3 18 IMPROPER USE Do not use this welder for pipe thawing. 19 HANDLING Ensure the handle is correctly fitted and always use safe lifting practices when lifting. Lotus Tool Group ®...
- Page 4 To limit the risk of injury, fire, or electrocution always follow the recommendations indicated. Read this Instruction manual carefully before using the welder and keep it in a safe place for future reference. Lotus Tool Group ®...
- Page 5 Do not use in rain or store in locations a ffected by rain. Recycle/dispose of packaging materials in accordance to the regulations and requirement of your local council. Lotus Tool Group ®...
-
Page 6: Rating Information
RATING INFORMATION LT255MTX Flux cored self shielded arc welding MMA Welding LIFT TIG Welding Rated no-load voltage Supply circuit, single phase alternating Rated supply voltage current and 50/ 60 Hz Duty cycle Conventional welding voltage Rated maximum supply current Maximum effective supply current... -
Page 7: Intended Use
5.MIG welding speed adjusting & MMA current adjusting knob 6.MIG welding voltage compensation adjusting knob 7.TIG/MMA/Flux cored0.8/Flux cored1.0 Switch function 8.ON/OFF Switch PACKAGE CONTENT 1. Protective Mask 2. Cleaning Brush 3. 1.4m Cable With Earth Clamp 4. 1.6m Cable With Electrode Holder Lotus Tool Group ®... -
Page 8: Operation
Allow the weld to cool, the slag can be removed by tapping it lightly with the cleaning brush. WARNING! Ensure that you have protective gloves and clothes to cover your hands and arms. Do not start welding before your eyes are properly protected by the hand held welding mask or welding helmet. Lotus Tool Group ®... - Page 9 MIG WELDING(Flux 0.8/Flux 1.0) Lotus Tool Group ®...
- Page 10 MMA WELDING Lotus Tool Group ®...
- Page 11 TIG WELDING(TIG torch is not supplied) Lotus Tool Group ®...
-
Page 12: Maintenance
Supply voltage is uneven, tool low or too high. The machine over heat Over-heating Check that cooling air can flow without obstructions indicator light swithes Machine’s volume-capacity ratio has been exceed, wait for the indicator light to switch off. Lotus Tool Group ®... -
Page 13: Technical Data
TECHNICALDATA MODEL LT255MTX ITEM Input Voltage(V) 1PH 220-240 Frequency(Hz) 50/60 Rated Input Capacity(KVA) 4.3K No-load Voltage(V) Duty Cycle(%) MIG 50-250A Current Range(A) MMA 20-250A TIG 10-250A Power Factor 0.73 Insulation Class Protection Degree IP2 1 Lotus Tool Group ®...
Need help?
Do you have a question about the LT255MTX and is the answer not in the manual?
Questions and answers