Page 1
OWNER'S MANUAL WD-1031R(H)D / 1035R(H)D WD-1231R(H)D / 1235R(H)D Thank you for buying a LG Fully Automatic Washing machine. Please read your owner's manual carefully, it provides instructions on safe installation, use and maintenance. Retain it for future reference. Record the model and serial numbers of your washing machine.
roduct Feature n Automatic process from washing to drying. Automatic process from washing to drying can be selected easily. Washing capacity : 6.5 kg (Cotton) Drying capacity : 3.0 kg (Cotton) n More economical by Intelligent Wash System Intelligent Wash System detects the amount of load and water temperature, and then determines the optimum water level and washing time to minimize energy and water consumption.
arnings READ ALL INSTRUCTIONS BEFORE USE For your safety, the information in this manual must be followed to minimize WARNING! the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. IMPORTANT SAFETY INSTRUCTIONS WARNING To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions, including the following:...
pecification Power plug If the supply cord is damaged, it must be replaced by the manufacturer or its service agents Drawer or a similarly qualified person in (For detergent and order to avoid a hazard. fabric softener) Control panel Drain hose Door Lower cover Leveling leg...
nstallation Install or store where it will not be exposed to temperatures below freezing or exposed to the weather. Properly ground washer to conform with all governing codes and ordinances. The base opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
nstallation n Installation place requirement Level floor : Drain Hose Allowable slope under entire washer is 1û Washer Power outlet : Must be within 1.5 meters of either side of location of washer. Do not overload the outlet with more than one appliance. Laundry Additional Clearance : approx.
nstallation n Electrical connection 1. Do not use an extension cord or double adapter. 2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly qualified person in order to avoid a hazard. 3.
Page 8
nstallation n Normal Tap without thread & screw type inlet hose Unscrew the fixing screw to Push the connector up till the Push the water supply hose attach the tap. rubber packing is in tight contact vertically upwards so that the with the tap.
nstallation n Installation of drain hose ca. 100 cm ca. 145 cm ¥ When installing the drain hose sink, secure it tightly with a string. ca. 105 cm ¥ Proper securing the drain hose will protect the floor from damage due to water leakage.
nstallation n Level adjustment 1. Leveling a the washing machine properly prevents excessive noise and vibration. Install the appliance on a solid and level floor surface, preferably in a corner of the room. 2. If the floor is uneven, adjust the leveling feet as required.
are before washing n Caring before washing 1. Care Labels Look for a care label on your clothes. This will tell you about the fabric content of your garment and how it should be washed. 2. Sorting To get the best results, Sort clothes into loads that can be washed with the same wash cycle. Water temperature and spin speed and different fabrics need to be washed in different ways.
dding detergent n Adding detergent and fabric softener 1. The Dispenser Drawer 3. Detergent dosage • The detergent should be used according to the instruction of the detergent manufacture. • If too much detergent is used more than the recommended amount, too many suds can occur and this will decrease the washing result or cause heavy load to the motor.
unction Recommended courses according to the laundry type Fabric Proper Washing Maximum Time Program Temp. Washing Drying Type (Option) (Option) Load Minutes (Option) Color fast garments Coloreds (shirts, night dresses, 40ûC 120(min.) Main(+Pre) Rating pajamas...)and lightly (Cold, 30ûC, (60,30/90/150) soiled white cotton 50ûC, 60ûC) (underwear...) First check if laundry is...
ow to use washer 95˚C Time Delay 30/90/150 Rinse Hold 1000 Coloreds Synthetic Start Ttime Left Super Whites Wool Pause No Inlet (min.) No Drain Rapid Delcate Main Cold Normal No Spin Time Water Door Rinse Spin Wash Delay gram Temp.
Page 15
ow to use washer 95˚C 30/90/150 Time Delay Rinse Hold 1000 Coloreds Synthetic Start Ttime Left Super Whites Wool Pause No Inlet (min.) Rapid No Drain Delcate Main Cold Normal No Spin Water Time Door Rinse Spin Wash Delay gram Temp.
ow to use washer 3. Rinse Hold 1. Spin selection ¥ If you desire to leave fabrics in the ¥ Spin rpm is available according to the machine without spinning after rinse to program as follows. prevent them from getting wrinkled, you - Coloreds may select rinse hold by pressing the 800E 1000E (1200)E No SpinE 400E (600)
Page 17
ow to use washer D r y 2. Drying guide ¥ Your dryer can handle a load of up to 3kg ¥ This washer-dryerÕs 30/90/150 dry weight of articles. automatical process from washing to drying can be ¥ When loading, shake out each handful of selected easily.
ow to use washer Water Temp. ¥ By pushing the Temp 1. Child lock button, the water 95˚C temperature can be ¥ Child lock can be set by pressing the 50 C selected. Water Temp. button and Time delay button - Cold simultaneously.
Page 19
ow to use washer Time Delay ¥ By selecting ECO, the Time Left Time Left water temperature is reduced and washing time No Inlet Time Time is lengthened. so you can Delay No Drain Delay economize in your consumption of energy. 1.
Page 20
ow to use washer Start/Pause Door Lock ¥ It shows whether the door Start can be open or not. Pause Door Lock ¥ When the lamp is on, the door can not be open. 1. Start ¥ This Start/Pause button is used to start wash cycle or pause the cycles.
Page 21
ow to use washer Display 3. Completion of washing Time Left ¥ When washing cycle is completed, Ò Ó is displayed on the ÒMulti displayÓ. 1. Special function display 4. Time left ¥ When child lock is selected, the ¥ During washing cycle, the remaining Ò...
aintenance Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock to avoid electrical shock hazards. n The water inlet filter - " No Inlet " error message will blink on the control panel when water does not enter the detergent drawer.
aintenance n Dispenser drawer After a while detergents and fabric softeners leave a deposit in the drawer. ¥ It should be cleaned from time to time with a jet of running water. ¥ If necessary it can be removed completely from the machine by pulling it out. ¥...
aintenance n Cleaning your washer 1. Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a neutral non abrasive household detergent. Immediately wipe off any spills. Wipe with damp cloth. Try not to hit surface with sharp objects.
roubleshooting guide This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately When the machine does not function properly or does not function at all, check the following points before you call the Service Department.
Page 26
roubleshooting guide Symptom Possible Cause Solution Washer does not start ¥ Electrical power cord may not Make sure plug fits tightly in wall be plugged in or connection outlet. may be loose. ¥ House fuse blown, circuit Reset circuit breaker or replace fuse. breaker tripped,or a power Do not increase fuse capacity.
Page 27
roubleshooting guide Symptom Possible Cause Solution Check another tap in the house. ¥ Water supply it not adequate in area Fully open tap. ¥ Water supply taps are not completely No Inlet Straighten hose. open. Check the filter of the inlet hose. ¥...
Need help?
Do you have a question about the WD-1031RD and is the answer not in the manual?
Questions and answers