MORDOMUS iAQ50W Manual

EN
iAQ50W – Air quality sensor
Features:
• Wi-Fi;
• Reading indoor Air quality.
Applications:
•
Indoor air quality monitoring.
Electrical Specifications:
Power supply voltage: 15VDC
Consumption: 150 mA @ 15VDC
Storage Temperature: -10ºC to 60ºC
Operating Temperature: 10ºC to 50ºC
Maximum humidity: 80% non-condensing
Wireless standards: WI-FI 2,4GHz
Physical Specifications:
Dimensions: 80mm X 80mm X 20mm.
Protection degree: IP20, for indoor use.
Reading ranges
Temperature: [0 - +60] ºC
Relative humidity: [0 - 100] %
eCO2: [400 - 65000] ppm
iAQ5W
https://
mordomus.com/
mordomus/
docs/wifi/
iAQ50W.pdf
TVOC: [0 - 65000] ppb
AQI-UBA: [1 - 5] level
Wi-Fi connectivity
Wall fixing 1.5m high
After turning on the iAQ50W for the first time, a 1-day calibration period
may be required to stabilize the readings.
ATTENTION:
Mordomus shall not be liable for any damages resulting from the
use of our equipment outside the specifications and/or for a purpose
other than that intended.
Assure Wi-Fi signal strength of at least 2 bars.
Overview:
ower supply connector
P
Visual AQI indicator
Connection status indicator
Enrollment button
1. Installation
Caution! Before installing the device, make sure that the mains power
is turned off.
1. Disconnect from mains power.
2. Perform the connections according to the schematic.
3. Power up.
2. Connection to WI-FI network and enrollment to Mordomus
Method 1 - Automatic Setup (Router must support WPS)
1. Since factory, on powering up the iAQ50W is in WPS negotiation mode
signaled by the connection status indicator blinking fast continuously.
Take care not to power up more than one iAQ50W device at the same
time since WPS allows for configuration of only one device at a time. We
recommend powering up and registering the devices in a sequential manner.
2. Press the WPS button on the router according to the user manual of this
device and wait until the WPS negotiation is completed. This is signaled by 2
short blinks of the connection status indicator every 2 seconds.
3. Activate the pairing mode in the Mordomus Software by clicking the Start
inclusion button in the device registration menu.
To reach this menu from the main screen click Configurations →
Modules/Addresses → Plus Button [+]
This mode is limited to 5 minutes in software and on the iAQ50W device for
safety reasons.
4. After the iAQ50W device shows up in the list make sure to click the button
Allow.
The connection status indicator should remain off.
From now on the iAQ50W device is ready to use.
Method 2 - Manual Setup
v.2443 1/8