Preparation For Use; Antenna/Cable Connections; Connecting To An External Device (Front) - Magnavox MWC20T6 Owner's Manual

P
REPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

Plug the incoming cable into the ANT. jack on the rear of the unit.
If your cable service supplies you with a converter box or if you use a satellite system, connect the box with
this unit as shown below.
Cable Antenna
TV signal or
OR
Incoming cable from Cable Company
or Satellite Antenna
NOTE:
Before plugging the antenna into
the ANT. jack of the unit, check
that the pin is not bent. If it is bent,
straighten the pin as illustrated,
then plug the pin into the ANT. jack
of the unit.

CONNECTING TO AN EXTERNAL DEVICE (FRONT)

When you watch a program recorded on another source (VCR or video camera), use the
AUDIO/VIDEO input jacks on the front of the unit.
Connect the Audio/Video output jacks of another source to the AUDIO L/R and VIDEO
jacks of this unit.
Then use [SELECT] or [CH. K K / L L ] until "AUX" appears on the screen.
ex.
VCR or video
camera, etc.
NOTE:
When you connect a monaural VCR (another source) to this unit, connect the Audio output jack of the monaural VCR
(another source) to the AUDIO L jack of this unit. The audio will output in both L and R channel equally.
6
EN
Incoming cable from home
Antenna / Cable Company
(No Cable Box)
Cable Box or Satellite Box*
Bent pin
Cable
Plug
(Needs to be
straightened)
To the Audio output jacks
Audio Cable (commercially available)
(OUT)
To the Video output jack
Video Cable (commercially available)
(OUT)
ANT. AUDIO OUT
COAXIAL
ANT.
*NOTE
(DO NOT DISCONNECT FROM BOX)
Some cable TV systems use scrambled
signals and require a special converter to
receive these channels. Consult your local
cable company.
For your safety and to
avoid damages to the unit,
unplug the antenna cable
from the ANT. jack before
(Straight pin)
moving the unit.
HEADPHONE VIDEO
Rear of the unit
AUX
(IN)
L – AUDIO – R
Front of the unit
(IN)