Connecting Your Dvd Player With Component Output - NEC VT70 User Manual

Connecting Your DVD Player with Component Output

Optional 15-pin - to - RCA (female)
3 cable (ADP-CV1)
Component video RCA 3
cable (not supplied)
You can connect your projector to a DVD player with component output or Video output. To do so, simply:
1. Turn off the power to your projector and DVD player.
2. If your DVD player has the component video (Y,Cb,Cr) output, use a commercially available component video cable
(RCA 3) and the optional 15-pin-to-RCA (female) 3 cable to connect your DVD player to the COMPUTER IN
connector on the projector.
For a DVD player without component video (Y,Cb,Cr) output, use common RCA cables (not provided) to connect a
composite VIDEO output of the DVD player to the Video Input of the projector.
3. Connect the supplied power cable. See page 20.
4. Turn on the projector and DVD player.
A component signal will be automatically displayed. If not, from the menu, select [Advanced]
[Computer], and then place a check mark in the Component radio button.
NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.
VT676/VT670/VT575/VT470
COMPUTER 1 IN
VIDEO IN
AUDIO R
L/MONO
S-VIDEO IN AUDIO
L/MONO R
DVD player
Y Cb Cr L R
Component AUDIO OUT
2. Installation and Connections
AUDIO
COMPUTER 1 IN AUDIO COMPUTER 2 IN
AUDIO OUT PC CONTROL
MONITOR OUT
AC IN
Audio Equipment
Audio cable (not supplied)
18
VT47
COMPUTER IN
AUDIO AUDIO
VIDEO IN COMPUTER IN
L/MONO R
S-VIDEO IN PC CONTROL
MONITOR OUT
AUDIO IN
L R
[Signal Select]