Disconnecting The Usb Portbar; Replacing The Usb Portbar Cable - NEC USB PORTBAR Manual

With the driver installation diskette
Table of Contents

Advertisement

Disconnecting the USB PortBar

Disconnect the USB PortBar from your NEC Versa as follows.
Note
Disconnect and connect the USB PortBar with the NEC Versa system powered on or in
Standby mode.
Do not unplug any peripheral devices connected to the USB PortBar with the NEC Versa system
powered on or in Standby mode.
Remove the small connector end of the USB cable from the back side of the USB PortBar.
1.
Remove the larger connector end of the USB cable from the USB port on the NEC Versa.
Disconnecting the USB PortBar from your NEC Versa
Place the USB cable back into its holder on the USB PortBar. Note that the smaller and
2.
larger connector fit into slots based on the size of the end of the cable.
Push down on the cable between the teeth marks to ensure a proper fit for storing.
3.

Replacing the USB PortBar cable

NEC USB PortBar with the Driver Installation Diskette 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the USB PORTBAR and is the answer not in the manual?

Table of Contents