LINQ LQ48033 Product Manual

FCC
This device complies with part 15 of the FCC results. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a class B digital device, pursuant to Part 15 of the Federal Communications
Commission (FCC) rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1.1. Reorient or relocate the receiving antenna.
1.2.Increase the separation between the equipment and receiver.
1.3.Connect the equipment into and outlet on a circuit diff erent from that to
which the receiver is connected.
1.4.Consult the dealer or an experienced radio/TV technician for help.
Changes or modifi cations not expressly approved by the manufacturer could void
the user's authority to operate the equipment.
DECLARATION OF CONFORMITY
LINQ declares that this product is in compliance with the essential requirements
and other relevant provisions of applicable EC directives. For Europe, a copy of the
Declaration of Conformity this product may be obtained by visiting
www.LINQconnects.com
EU DECLARATION OF CONFORMITY
Declaration number: DOCL231012
Name and address of Telco Accessories B.V.
manufacturer / EU-AR: Hoofdveste 19
Houten
Netherlands
THIS DECLARATION OF CONFORMITY IS ISSUED UNDER THE SOLE RESPONSIBILITY OF:
Name and address of Telco Accessories B.V.
manufacturer: Hoofdveste 19
Houten
Netherlands
Product identification: Brand: LINQ Connects
Name: LINQ 140W GaN2 Wall charger
Model: LQ48033
We declare that the product described above, to which this EU Declaration of Conformity refers to, is in conformity
with the essential requirements of the following legislation:
EU Community Legislation European Council Restriction of Hazardous Substances (RoHS) Directive 2011/65/EU And
Amendment (EU)2015/863, through the technical standards and/or specifications below:
IEC 62321-3-1:2013
IEC 62321-5:2013
IEC 62321-4:2013+AMD1:2017CSV
IEC 62321-6:2015
IEC 62321-7-1:2015
IEC 62321-7-2:2017
IEC 62321-8:2017
Harmonised standards European Council Electromagnetic Compatibility (EMC) Directive 2014/30/EU, through the
technical standards and/or specifications below:
EN 55032:2015+A11:2020
EN 55035:2017 +A11:2020
EN IEC 61000-3-2:2019
EN 61000-3-3:2013+A1:2019
SIGNED FOR AND ON BEHALF OF:
Place and date of issue: Houten, 30 November 2023
Signature:
Name, function: Armand van Oord, R&D Director LINQ connects Armand van Oord R&D Director LINQ conne
Company name: Telco Accessories B.V.
WEEE Information
According to the WEEE (Waste Electrical and Electronic Equipment) Directive,
do not dispose of this product as household waste or commercial waste. Waste
electrical and electronic equipment should be appropriately collected and recycled
as required by practices established for your country. For information on recycling
of this product, please contact your local authorities, your household waste disposal
service, or the shop where you purchased the product.
+31 (0)30 - 635 48 00
info@LINQconnects.com
Hoofdveste 19, 3992 DH, Houten, Netherlands
www.LINQconnects.com
140W GaN Charger
Model #: LQ48033
Product Manual / Manuel du produit
/ Manuale del prodotto / Instrukcja
obsługi produktu / Produkthandbuch
/ Manual del producto / Manual do
produto / Příručka k výrobku / Produkta
rokasgrāmata
www.LINQconnects.com