Trouble Shooting - NEC NW-452 Instruction Manual

Full-auto electric washing machine
Table of Contents

Advertisement

TROUBLE SHOOTING

Most problems are easily solved if you understand the cause.
Check the following list for problems before calling for service.
Before calling for service, check the followings;
PROBLEM
• The washer will not
operate at all.
Water is not supplied;
If water supply is not finished within 30
minutes, the lamp
will light up, and
the buzzer will sound to indicate a problem.
The washer will not drain;
If the drain is not finished within selected
time, lamp
will light up, and the buzzer
will sound to indicate a problem.
The washer will not spin;
If the clothes are collected on one side
during spin and the tub becomes
unbalanced, the spin operation will be
interrupted, and then this unbalanced
condition will be corrected by following
operation: WATER SUPPLY RINSE
DRAIN However if the unbalanced
condition is unchanged despite repeating
the above operation, the lamp
will
light up, and the buzzer will sound to
indicate a problem.
• Is there a power failure?
• Is the power cord correctly connected to an electrical outlet?
• Is the electric fuse broken?
• Did you turn on the power?
• Did you press the Start/Hold button?
• Is there correct amount of water in the tub?
• Did you connect the inlet hose and open the water tap?
• Is the inlet hose or the water tap frozen?
• Is the water supply shut off?
• Does foreign matter block the inlet hose filter?
• Is the drain hose frozen or blocked up by dirt?
• Is the drain hose kinked or deformed?
• Is the end of the drain hose immersed in water?
• Is there excessive dirt inside the pump housing?
• Are the clothes in the tub collected on one side?
• Is the washing machine installed on an uneven floor or is the
vibration serious?
• Is the lid open?
(The lamp
will light up in this case.)
15
CHECK POINT

Advertisement

Table of Contents
loading

Table of Contents