Lancom 1936VAG-5G Hardware Quick Reference

Mounting & connecting
Hardware Quick Reference
LANCOM 1936VAG-5G
➀
➁ ➂ ➃
➀ 5G antenna connectors
Connect the supplied cellular antennas to the connectors
MAIN / AUX or MIMO1 / MIMO2 at the front of the device.
➁ G.FAST / VDSL / ADSL interfaces*
If required, use the supplied DSL cables for the IP-based line to connect
each G.FAST / VDSL / ADSL interface to a separate provider' s telephone
socket. For more information, please contact your Internet service
provider.
* Please use the appropriate cables depending on the design
➂ WAN 1 interfaces (SFP / TP combo port)
Insert a suitable SFP module (e.g. 1000Base-SX or 1000Base-LX) into the
SFP port. Choose a cable compatible with the SFP module and connect it
as described in the module' s documentation. SFP modulel and cable are
not included.
If desired, alternatively connect the WAN 1 TP interface to a WAN modem
using an ethernet cable.
➃ WAN 2 interface (TP)
Connect the WAN 2 interface to a WAN modem using an Ethernet cable.
➄ Ethernet interfaces
Use the cable with the kiwi-colored connectors to connect one of the
interfaces ETH 1 to ETH 4 to your PC or a LAN switch.
➅ Analog interfaces
Connect analog terminal devices to the analog interfaces either directly
via RJ11 or with the help of the enclosed TAE adapters.
Before initial startup, please make sure to take notice of the information regarding the intended use in the enclosed
installation guide!
Operate the device only with a professionally installed power supply at a nearby power socket that is freely
accessible at all times.
The power plug of the device must be freely accessible.
Please note that support for third-party accessories is not provided.
➃ ➄ ➅
➆ ISDN interfaces
ISDN 1: Internal (NT) ISDN bus
ISDN 2: Internal (NT) ISDN-bus
A 100-Ohm resistor for line termination is switchable in LCOS.
➇ SIM card slots
Slide the SIM cards into the SIM card slots using the marker to ensure
that the cards are the right way round. Ensure that the SIM cards click
into place on insertion. To remove the cards from the device, press the
card lightly into the device.
Let go to release the SIM cards from the slot.
➈ Configuration interface
Use the included serial configuration cable to connect the serial
interface (COM) to the serial interface of the device you want to use for
configuring / monitoring.
10 USB interface
You can use the USB interface to connect a USB printer or a USB storage
device.
Power connector and grounding point
11
(device back side)
Supply power to the device via the power connector. Please use the IEC
power cable supplied (separately available for WW devices).
12 ATTENTION: High touch current possible! Connect to earth before
connecting the power supply.
Please observe the following when setting up the device
i
→ For devices to be operated on the desktop, please attach the adhesive rubber footpads
→ Do not rest any objects on top of the device and do not stack multiple devices
→ K eep all ventilation slots of the device clear of obstruction
→ Mount the device into a 19" unit in a server cabinet using the provided screws and mounting brackets.
Pay attention to the "R" and "L" marks on the brackets for accurate mounting.
➀
➆
➇ ➈ 10
11
12
Warning! High touch current.
Connect to earth before
connecting the power supply.