Related Manuals for Russell Hobbs GLIDE PRO PLUS
Summary of Contents for Russell Hobbs GLIDE PRO PLUS
- Page 1 GLIDE PRO PLUS Operating Manual RHHS4101-AU russellhobbs.com.au russellhobbs.co.nz...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS • It is hazardous for anyone other than a competent person to carry out any service or repair operation that involves the removal of a cover which gives protection against exposure to electrical parts. • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. - Page 3 IMPORTANT SAFETY INSTRUCTIONS • Do not use appliance if it has been dropped, damaged, left outdoors or dropped into water. Do not operate this appliance for anything other than its intended use. • Keep the appliance and adapter away from water; do not allow it to get wet.
-
Page 4: Product Overview
PRODUCT OVERVIEW Charger Unit Filter Dust Canister Cyclone unit Dust Canister Metal Tube Floorhead Crevice tool Wall mount & brush tool & fixtures... - Page 5 ASSEMBLY & POWERING ON Allow to charge for 3 Hours before first use SURFACE COMPATIBILITY Carpet Upholstery Hard Floors...
-
Page 6: Operation
OPERATION Power CAUTION On/Off Exhaust air discharged from the sides of the cleaner may extinguish an open flame Speed Control TOOL ATTACHMENTS CARRYING THE APPLIANCE CAUTION Take care using as a carry handle TOOL ATTACHMENTS *Do not use on animals... -
Page 7: Emptying The Dust Container
EMPTYING THE DUST CONTAINER STAIRS SURFACE USAGE Normal Power All modes suitable CHECKING FOR BLOCKAGES... -
Page 8: Cleaning The Exhaust Filter
CLEANING THE VACUUM CLEANING THE EXHAUST FILTER... - Page 9 CLEANING THE VACUUM Taking care, press the clasp and lift the small cover off the brush head. Remove the brush roll taking care not to lose any small pieces. Taking care to cut only the hair, use scissors to ensure the brush roll is completely hair free.
- Page 10 INDICATORS & WARNING LIGHTS The three LED lights on the appliance will indicate different status of the vacuum. Light Sequence Status 1 Flashing, 2 OFF during charging Vacuum is charging 1 ON, 2 Flashing Vacuum half charged 1 & 2 ON for 10min then OFF during charging Vacuum is fully charged 1 &...
-
Page 11: Problem Solving
PROBLEM SOLVING The vacuum cleaner • Check the vacuum is plugged in doesn’t switch on • Check the socket is switched on • Check another appliance in the socket • Check for any obvious signs of damage to cord or plug •... -
Page 12: Customer Service And Warranty
CUSTOMER SERVICE & WARRANTY Spectrum Brands New Zealand Ltd Spectrum Brands Australia Pty Ltd PO Box 9817 Newmarket Locked Bag 3004 Braeside Auckland 1149 New Zealand Victoria 3195 Australia Customer Service in New Zealand Customer Service in Australia Toll Free: 0800 736 776 Toll Free: 1800 623 118 Email: info@spectrumbrands.co.nz Email: info@spectrumbrands.com.au... - Page 13 Warranty Conditions Warranty Conditions The Goods must be used in accordance with the manufacturer’s instructions. This Warranty does not apply should the defect in or failure of the Goods be attributable to misuse, abuse, accident or non-observance of manufacturer’s instructions on the part of the user. As far as the law permits, the manufacturer does not accept liability for any direct or consequential loss, damage or other expense caused by or arising out of any failure to use the Goods in accordance with the manufacturer’s instructions.
- Page 14 Revision 1.1...
Need help?
Do you have a question about the GLIDE PRO PLUS and is the answer not in the manual?
Questions and answers