Kalamazoo S272 How To Use

How to Use the S272 2 x 72 Inch Table Grinder
Safety Preparation
•
Wear Protective Gear: Ensure you have safety goggles and ear protection. If working
with materials that produce fumes, wear a respirator.
•
Check Work Area: Make sure the work area is clear of unnecessary tools, materials, and
debris.
Inspect the Grinder: Verify that the grinder's belt is correctly installed, tensioned, and
•
free of tears or excessive wear. Check that the grinder is stable and that all safety guards
are securely in place.
Setting Up the Grinder
•
Select the Belt: Choose the appropriate belt for your task (e.g., coarse grit for rough
grinding, finer grit for finishing). Attach the belt by loosening the tension mechanism,
placing the belt on the pulleys, and then retightening.
•
Adjust the Table and Angles: Set the worktable to the desired angle or height,
depending on your grinding needs. Make sure the table is locked securely in place.
•
Check Belt Tracking: Turn on the grinder briefly to check the tracking (alignment) of
the belt. Adjust the tracking knob as needed so the belt runs centered on the pulleys.
Operating the Grinder
•
Turn On the Grinder: Ensure you have a steady stance, then power on the grinder.
•
Start with Light Pressure: Begin grinding with a gentle touch, allowing the abrasive to
do the work. Too much pressure can wear down the belt quickly or damage the material.
•
Keep a Consistent Angle: Hold your material at a consistent angle to achieve an even
grind. Avoid changing angles mid-grind to prevent uneven results.
•
Move Continuously: Keep the material moving across the belt to prevent excessive heat
buildup and avoid grinding grooves into the material.
Grinding Techniques
•
For Flat Grinding: Keep the material flat against the table and use a back-and-forth
motion. This helps create a uniform surface finish.
•
For Sharpening or Edge Grinding: Hold the edge of your material at a slight angle to
the belt. Move it slowly and evenly across the belt to create a sharp edge.