Kalamazoo S272V Operation And Maintenance Manual

Mastering the S272V 2 x 72 Inch Grinder with Vacuum:
Setup, Operation, and Maintenance Guide
Unpacking and Assembly
1. Inspect Packaging: Upon receiving the grinder, carefully inspect the packaging for
any signs of damage. If damage is evident, document it and contact the supplier
immediately.
2. Verify Contents: Ensure all components are present, including the grinder unit,
vacuum system, worktable, contact wheels, and user manual.
1. Voltage Verification: Confirm that the grinder's voltage matches your power supply.
The S272V is available in various voltage configurations; ensure compatibility before
plugging in.
2. Grounding: Ensure the grinder is properly grounded to prevent electrical hazards.
Use a certified electrician if you're unsure about the grounding process.
3. Power Connection: Connect the grinder to a dedicated circuit to avoid overloading.
Ensure the power switch is in the 'OFF' position before plugging in.
Belt Installation:
Open the side panel to access the belt area.
o
Place the 2 x 72-inch sanding belt over the contact wheels, ensuring it's
o
centered.
Use the tension adjustment knob to secure the belt firmly.
o
Adjusting the Platen:
The platen can rotate 360 degrees to accommodate various grinding tasks.
o
Unpacking
Electrical Setup
Operating Instructions