CONTENTS Page(s) Safety Instructions and Electrical Safety 3 - 7 Pad Feature Diagram Control Feature Diagram Using your Electric Pad 10-12 Cleaning and Care 13-15 Problem Solving Guarantee and Customer Services Connection to the Mains Supply Specification Disposal Information...
SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions should always be observed, including the following: • Read all instructions. • Check that your mains voltage corresponds with the rating on the appliance. • To protect against electrical shock do not immerse cord, plug, or appliance in water or other liquid.
Page 4
SAFETY INSTRUCTIONS • Do not use outdoors. • This product is only intended for heating. • If overheating should occur, the built-in overheating safety device will shut the appliance off. • The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances.
Page 5
SAFETY INSTRUCTIONS • Warning: Children should not use this appliance. Close supervision is necessary when any appliances are used near children. • It is recommended that a qualified and registered person inspect your appliance after each 3 years of use. •...
Page 6
SAFETY INSTRUCTIONS • If any abnormality or defect in operation of this appliance is observed, discontinue its use immediately and consult the manufacturer or a licensed electrician. • Regularly inspect the supply cord, plug, controller and appliance for any damage. If found damaged in any way, immediately cease use of the appliance and return to store or authorized service agent for inspection.
ELECTRICAL SAFETY THIS APPLIANCE MUST BE PLUGGED INTO AN EARTHED SOCKET • Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 220 – 240V AC; 50Hz.
USING YOUR ELECTRIC PAD Ensure you remove all packaging and inspect for damage prior to use. If damage is found do not use the appliance. 1. Place the pad on a dry and heat-resistant surface. 2. Secure the detachable power cord to the pad if not already attached.
Page 11
USING YOUR ELECTRIC PAD Note: If you choose to use this appliance for an extended period of time, such as when falling asleep, the low setting (1) should be used in order to avoid conditions such as skin burns and/or heat stroke.
Page 12
USING YOUR ELECTRIC PAD Below are some examples of how to use your heated pad: • To warm the couch. • On top of you while on the bed. • Lightly wrapped around your body in areas such as your neck, back, shoulder, arm, leg or stomach etc.
CLEANING AND CARE WARNING: Electrical Shock Hazard. Note: Before any cleaning, ensure the appliance is turned off and remove the plug from the wall socket. Note: Do not allow the controller to come in contact with any wet solution. Before you clean the appliance, disconnect the mains plug from the wall socket.
Page 14
CLEANING AND CARE Washing Instructions Only use the below instructions: • Hand wash or spot clean if possible • Only machine wash on a wool/delicate cycle • Do not machine wash above 40°c • Do not tumble dry • Do not wring •...
Page 15
CLEANING AND CARE • Rinse the heated pad thoroughly in clean fresh water. • Unfold the heated pad and allow to dry naturally. Drying • Do not tumble dry • Do not iron • Do not use pegs to secure the pad in position. •...
PROBLEM SOLVING My appliance does not work when I turn it on: 1. Check that your appliance is plugged in and the power is turned on at the mains socket. 2. Try another mains socket. 3. Check that the control has been set to the correct setting and is not in the off position 4.
GUARANTEE AND CUSTOMER SERVICES This product is guaranteed for 12 months from the date of the original purchase. If any defect arises due to faulty materials or workmanship, the faulty product must be returned to the place of purchase. Refund or replacement is at the discretion of the retailer. The following conditions apply: •...
CONNECTION TO THE MAINS SUPPLY This appliance is designed to operate from a mains supply of 220-240V~50Hz. Check that the voltage marked on the product corresponds with your supply voltage. How to change the fuse 1. Slot the end of a screwdriver into the recess in the fuse holder of the plug.
Swan Lane, Hindley Green, Wigan, WN2 4AY, United Kingdom / Product Care (Ireland) Ltd, Unit 3D North Point House, North Point Business Park, New Mallow Road, Cork, T23 AT2P, Ireland. Russell Hobbs is the registered trademark of Spectrum Brands (UK) Ltd.
Need help?
Do you have a question about the RHHPS1001 and is the answer not in the manual?
Questions and answers