Table of Contents
Advertisement
3. If installing a single switch only, turn to "Connecting to a Power
Source" at the end of this chapter.
4. If installing multiple switches, mount them in the rack, one below the
other, in any order.
5. If also installing RPUs, mount them in the rack below the other
devices.
Desktop or Shelf Mounting
1. Attach the four adhesive feet to the bottom of the first switch.
2. Set the device on a flat surface near an AC power source, making sure
there are at least two inches of space on all sides for proper air flow.
3. If installing a single switch only, go to "Connecting to a Power Source"
at the end of this chapter.
4. If installing multiple switches, attach four adhesive feet to each one.
Place each device squarely on top of the one below, in any order.
5. If also installing RPUs, place them close to the stack.
Figure 3-3. Attaching the Adhesive Feet
M
OUNTING
3-5
Advertisement
Table of Contents
