Arkon Slim-Grip TABRMAMPS Installation Instructions

TABRMAMPS | Slim-Grip® Tablet Holder with Drill-Base Mount
TAB001
APRM2T
Install the Dual T-Tab adapter into the tablet holder
Insert the Dual T-Tab adapter into the slot located behind
the holder. Then, slide the adapter upwards to ensure it is
securely in place.
Assemble the components
Locate the shaft arm and turn to the adjustment knob
counterclockwise to expand. Insert the 25mm ball ends into the
shaft. Turn clockwise to tighten.
WARNING
CHOKING HAZARD - Keep out of reach from children under 8 yrs. as they can choke or suffocate on parts included with this system
WARNING
Arkon® is not responsible for any damages caused to your device or yourself due to the installation or use of this mount. Do not install Arkon® products near areas that intefere with operation
of vehicles. Arkon® assumes no responsibility or liability for injury or death as a result of failure to install in a safe location. Arkon® is not responsible for any damages caused to vehicles,
product, or people due to the installation or use of this product.
SP-RM250
APAMPS25MM
USA (800) 841-0884
INT'L (626) 254-9005
Monday - Friday 9 am - 5 pm PST
Includes:
1 – Slim-Grip® Tablet Holder with Support Legs (TAB001)
1 – Robust™ Series 3.75 inch Shaft Arm (SP-RM250)
1 – 4-Hole AMPS to 25mm Ball Adapter (APAMPS25MM)
1 – 25mm Ball to Dual T-Tab Mounting Pattern Adapter (APRM2T)
Important: Clean the application surface and make sure it is free of dirt, dust, and grease
before installation.
Please note the TAB001 packaging includes:
5 - Support Stoppers (SP-TABS5PK) - Optional
10 - Support Legs (SPTAB1FT)
Leg selection guide
Recommended legs to use based on tablet size with or without a case
- For tablets size min 6.56" to max 8.94" we recommend using 2 small legs
- For tablets size min 7.03" to 9.50" max we recommend using 1 long leg and 1 small leg
- For tablets size min 9.50" we recommend using 2 long legs
Mount Installation
To secure the pedestal to the mounting surface, align the
screws (not included) with the AMPS adapter. If necessary,
detach the shaft from the adapter to streamline the
installation process.
Fully assembled
Refer to the image below for the full assembled product.
arkon.com
Designed in USA
©Arkon Resources, Inc.
Continued on page 2
Need assistance?
Scan to email our
Arkon® customer
service team.