SanaLoma Laser D20 Dice Box Assembly Instructions

To assemble the D20 Dice Box, follow each section using the parts indicated. You will need glue for some parts and some pieces may fit tightly, so keep
the glue and sandpaper handy and have fun!
Parts List
Inner triangle
pieces x20
Outer triangle
pieces x20,
20
numbered 1-20
Standard
Modified
connector x52
connector x2
with 2 extra
with 1 extra
Inner box
Inner box
support
pieces
Section 2 - Inner Base
Next lay out 15 inner
triangle pieces as
shown. You will need
40 standard
connectors for this
section. Glue the
connector between
the pieces at the holes
indicated (yellow/red).
BE SURE to NOT
add connectors to the
outer most holes on
the flat edge facing
up.
Set section aside to
dry.
D20 Dice Box - Assembly Instructions - Page 1
This kit was designed by Sanaloma Laser, LLC
Section 1 - Inner Lid
Start by laying out 5 inner
triangle pieces and 10
standard connectors to be
used for the lid. Glue the
connector between the
pieces at the holes
indicated (yellow/red). BE
SURE to NOT add
connectors to the outer
most holes.
Set section aside to dry.
This kit has been designed for persons over the age of 12.
THIS PRODUCT IS NOT A TOY!
SanaLoma Laser, LLC © 2022
SanaLoma
Laser
LLC
We Cut! You Assemble!
www.SanaLomaLaser.com