GT-416 Automatic Transmission Fluid Exchanger Precautions for safe use Only qualified personnel who have been trained can use the equipment. Use and operate the equipment only after reading and understanding the following regulations. Wear protective glasses when operating. Do not smoke near the equipment.
GT-416 Automatic Transmission Fluid Exchanger Brief description Automatic transmission fluid exchanger has become one of the necessary equipment in the automobile repair and maintenance industry. It is the latest one that uses the pressure of the car itself for circulation cleaning, thereby restoring the acceleration performance of the transmission.
GT-416 Automatic Transmission Fluid Exchanger Precautions for enabling equipment Refer to Figure A 1. Connect the power cord to the power supply, red to the positive pole and black to the negative pole. 2. Add the required new ATF oil to the new oil tank (the original oil storage of the automatic transmission is generally more than 8 liters, so add about 3 liters more than the original oil volume).
GT-416 Automatic Transmission Fluid Exchanger Features and functions of cleaning systems 1. New oil window: The cleanliness of the oil during oil change can be observed through the window; the comparison between the new oil and the used oil window when the new oil passes through the window.
Page 8
GT-416 Automatic Transmission Fluid Exchanger observe the oil storage capacity of the new and used oil tanks. The red one is connected to the positive pole and the black one is connected to the negative pole. C. New oil storage tank: store new ATF oil (15 liters).
GT-416 Automatic Transmission Fluid Exchanger Cleaning system cycle flushing process Note: Switch to Flushing Cleaning method without replacing the filter element: 1. Before cleaning and replacing the automatic transmission, the vehicle's power wheels must be off the ground (using a lift or jack).
Page 10
GT-416 Automatic Transmission Fluid Exchanger proceed to the next step of replacing the transmission oil. Note: When switching between forward gear and reverse gear, you should step on the brake first and then switch gear after the wheels stop. If the vehicle's transmission needs a filter replacement, the following steps should be performed after cleaning.
Page 11
GT-416 Automatic Transmission Fluid Exchanger Note: The process of exchanging ATF oil As shown in the figure: Switch to switch valve, indicating that the new and used oil are exchanged 1. Open the used and new oil regulating valve, turn to exchange switch, start the engine, start the electric pump, and start the gearbox to exchange the used and new oil.
Page 12
GT-416 Automatic Transmission Fluid Exchanger used oil in the gearbox flows. 3. 20-50 seconds depending on the situation . 4. Pay attention to the changes in transmission oil flow and color in the used oil window. You can adjust the flow rate of the used and new oil at any time.The throttle valve adjusts the flow rate.
GT-416 Automatic Transmission Fluid Exchanger Cleaning system used oil discharge process 1. Empty the used oil in the used oil tank before each oil change. 2. Open the back door of the equipment to take out the used oil tank, dispose of and recycle the used oil.
GT-416 Automatic Transmission Fluid Exchanger Troubleshooting Connect the power supply, press the button switch, the device does not work or work abnormally: 1. Check whether the power supply is properly connected and whether the positive and negative terminals are correctly connected.
GT-416 Automatic Transmission Fluid Exchanger Maintenance and care of cleaning system 1. The design of the equipment uses a fuse to protect the circuit, so the contact point between the fuse and the circuit should be checked regularly to see if it is loose.
Need help?
Do you have a question about the GT-416 and is the answer not in the manual?
Questions and answers