Magic Bullet MBR04B User Manual page 18

caution:
Before using the Cross Blade, check
the gasket to make sure it is not
damaged and it is completely seated in
the Cross Blade Unit before each use.
Never put your hands or utensils near
the moving Cross Blade and never use
your hands or utensils to press the
activator buttons down while the
Motor Base is plugged in.
If the Cross Blade stops spinning while
in lock on mode, immediately unplug
the magic bullet . Hard ingredients like
®
carrots or celery can get stuck in the
Cross Blade and stop it from turning. If
this happens, unplug the magic bullet
right away. Remove the blade/cup
assembly from the Motor Base, and
give ingredients a good shake to
unblock the Cross Blade. If the Cross
33
Blade still remains obstructed, twist
the Cross Blade attachment off of the
Cup and carefully spin the metal
blades using a utensil (not your fingers)
to release the blockage. Reattach the
Cross Blade to the Cup, plug in the
magic bullet and try again. It should
®
spin normally.
Never run the magic bullet for more
®
than one minute at a time, as it can
cause permanent damage to the
motor. If the motor stops working,
unplug the Motor Base and let it cool
for a few hours before attempting to
use it again. Your magic bullet
®
®
internal thermal breaker that shuts the
unit off when it overheats. Letting the
thermal breaker cool down should
allow it to reset.
care & maintenance.
Cleaning the magic bullet
for the Motor Base and Cross Blade) on the top rack of the dishwasher or
hand wash with warm, soapy water and rinse.
step 1:
Always power off
unplug the Motor Base from
the outlet when it is left
unattended, before assembling,
disassembling, changing
accessories or approaching parts
that move in use or when cleaning.
Do not attempt to handle the
has an appliance until all parts have
stopped moving!
step 2:
Make sure the Blending
Cup/Cross Blade is not attached to
the Motor Base.
is easy. Simply place any of the parts (except
®
step 3:
and Clean the individual
components (Motor Base, Cross
Blade, magic bullet
®
motor base:
• To avoid risk of injury,
your hands or utensils to clean
the White Actuator Tabs while
the magic bullet
®
• Never submerge the Motor Base
in water or put in the dishwasher.
• Do not remove the rubber or plastic
liners inside the Motor Base.
Blending Cups).
never use
is plugged in.
3 4