Subscribe to Our Youtube Channel
Related Manuals for Truper PRO DIMI-20A2
Summary of Contents for Truper PRO DIMI-20A2
- Page 1 6.5 mm 20 V 1/4” Manual Cordless Bit holder impact driver Applies for: Codes Models 103253 DIMI-20A2 103254 DIMI-20AS DIMI-20A2 CAUTION Read this manual thoroughly before using the tool.
-
Page 2: Table Of Contents
Warranty policy Use and care recommendations Use the provided charger or the one suggested by TRUPER to charge the battery. Follow the battery usage considerations (page 6-8). Follow the instructions for operation and functions (page 9). Always keep the vents free from obstruction to ensure proper cooling of the engine. -
Page 3: Technical Data
The construction class of the charger is: Reinforced insulation WARNING If the power cable is damaged, it must be replaced by the manufacturer or an Authorized TRUPER Service Center to prevent any risk of electric shock or significant accident. The electrical insulation of this tool is compromised by splashes or spillage of liquids during its operation. -
Page 4: General Safety Warnings For Electric Tools
Use and care of the battery-powered tool shoes, helmet, and ear protection in appropriate conditions significantly Only recharge with the charger specified by TRUPER. reduces the risk of personal injury. Using the charger specified for one battery with another battery can cause a fire hazard. -
Page 5: Safety Warnings For The Battery
CAUTION • Use only the screwdriver tips recommended WARNING CHOKING HAZARD! Children can by TRUPER. swallow small parts and choke. Keep small parts away • Keep the screwdriver tips in good condition; this reduces the from children. load on the tool and extends its lifespan. -
Page 6: Safety Warnings For The Battery Charger
Safety warnings for the battery WARNING Safety warnings for the battery charger ENGLISH... -
Page 7: Parts
Authorized TRUPER Service Center. • If the green light flashes, it indicates that the battery temperature is below 32 °F or above 113 °F. - Page 8 Preparation Considerations for battery use The battery is DISCHARGED from the factory. It will be necessary to charge it for approximately 3 hours before use. The normal charging temperature is from 32 °F to 113 °F. Charging is automatically suspended outside of this range until it reaches the correct temperature.
-
Page 9: Operation
Mantenimiento Operation Power on and operation control • Press the switch to start operation. Release the switch to stop operation. • The switch allows you to select the appropriate speed for each task. The tighter you press the switch, the faster the tool will operate. -
Page 10: Troubleshooting
• Keep the vents clean and free of obstructions to ensure Tool servicing should only be carried out at an proper cooling of the motor. Authorized TRUPER Service Center. Service and • Regularly inspect all mounting screws and ensure they maintenance performed by unqualified individuals are tightened correctly. -
Page 11: Authorized Service Centers
In the event of any problem contacting an Authorized TRUPER Service Center, please see our webpage WWW.TRUPER.COM to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-873 to get information about the nearest Service Center. -
Page 12: Warranty Policy
It includes the costs of transportation of the product that derive from its fulfillment of its service network. . Phone number 800-018-7873. Made in China. Imported by TRUPER, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257, Phone number 761 782 9100.
Need help?
Do you have a question about the PRO DIMI-20A2 and is the answer not in the manual?
Questions and answers