HomeAware HA360M-II Quick Start Manual

Setting Up Your HomeAware™ Main Unit for the First Time
Remove all contents of the box.
- HA360M-II - Main Unit
- HA360SA2.1 - Security Alert
- HA360V-II - Bed Shaker
- Midland NOAA Weather Radio
Connect Power Supply and Bed Vibrator
Plug the cord from the HomeAware-II's power supply into the 5.1V 2A DC IN connector on the back of the HomeAware
and then plug the power supply into a 120V outlet.
Plug the cord of the vibrator into the Vibrator jack on the rear of the HomeAware-II. The vibrator can be placed under
either the pillow or mattress. If it is under the pillow, the vibration will be stronger, but it could fall off the bed during
the night and you might not feel the vibration in the case of an emergency. If the vibrator is placed under the
mattress, the vibration may be weaker but there is less risk of it falling away.
Install Rechargeable Battery
Remove the battery cover from the bottom of the HA360M-II. Fully insert the battery connector into the matching
socket inside of the battery compartment. Push until you feel or hear a click to let you know it is in all the way. Insert
the battery into the battery compartment, taking care not to unplug or put stress on the battery cable. Reinstall the
battery cover and make sure it clicks into place.
Setting the Time of Day
Press the TIME SET button. Blinking red dots shown on the display indicate time set mode has been activated. Press
the HOUR buttons up or down and the MINUTES buttons up or down to set desired time. The PM indicator is located
on the top left-hand side. Press the ENTER button when done to complete the time setting. The display dots will stop
blinking to indicate the time has been set.
For additional information refer to the HA360M-II, HA360SA2.1 and Midland NOAA Weather User Guides.
HA360M-II Weather Bundle Quick Start Guide