English CORDLESS OSCILLATING MULTI‑TOOL DCS353 Congratulations! EC‑Declaration of Conformity You have chosen a D WALT tool. Years of experience, thorough Machinery Directive product development and innovation make D WALT one of the most reliable partners for professional power tool users. Technical Data Cordless Oscillating Multi-Tool DCS353 DCS353...
English Batteries Chargers/Charge Times (Minutes) Weight DCB104 DCB107 DCB110 DCB112 DCB113 DCB115 DCB116 DCB132 DCB119 Cat # DCB122 0.22 DCB124/G 0.25 DCB125 0.20 DCB126/G 0.46 DCB127 0.22 DECLARATION OF CONFORMITY DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or THE SUPPLY OF MACHINERY (SAFETY) serious injury.
English refrigerators. There is an increased risk of electric shock if will do the job better and safer at the rate for which it your body is earthed or grounded. was designed. c ) Do not expose power tools to rain or wet conditions. b ) Do not use the power tool if the switch does not turn Water entering a power tool will increase the risk of it on and off.
English f ) Do not expose a battery pack or tool to fire or • Impairment of hearing. excessive temperature. Exposure to fire or temperature • Risk of personal injury due to flying particles. above 130 °C may cause explosion. • Risk of burns due to accessories becoming hot g ) Follow all charging instructions and do not charge during operation.
English Charging a Battery (Fig. B) CAUTION: Children should be supervised to ensure that they do not play with the appliance. 1. Plug the charger into an appropriate outlet before inserting NOTICE: Under certain conditions, with the charger battery pack. plugged into the power supply, the exposed charging 2.
English Wall Mounting • Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persists, seek These chargers are designed to be wall mountable or to sit medical attention. upright on a table or work surface. If wall mounting, locate the WARNING: Burn hazard.
English Battery Type the latest regulations for packaging, labeling/marking and documentation requirements. The following tools operate on a 12 volt battery pack: DCS353 . The information provided in this section of the manual is These battery packs may be used: DCB122, DCB124, DCB124G, provided in good faith and believed to be accurate at the time DCB125, DCB126, DCB126G, DCB127.
English Inserting and Removing the Battery Pack Date Code Position (Fig. B) The date code , which also includes the year of manufacture, 10 from the Tool (Fig. B) is printed into the housing. nOTE: Make sure your battery pack 1 is fully charged. Example: To Install the Battery Pack into the Tool Handle 2021 XX XX...
Page 15
English Installing/Removing Sanding Sheets (Fig. F) Non-D WALT accessories can be attached using the universal adaptor. A diamond shaped platen 25 uses a hook and loop adhesion 1. Place the washer on the tool. 23 system to attach the sanding sheets . The platen allows you 26 ...
English OPERATION 2. Attach the sanding platen 25 as described under Installing/Removing Accessories. Instructions for Use 3. Attach sanding sheet as described under Installing/ Removing Sanding Sheets. WARNING: Always observe the safety instructions and applicable regulations. Using the Dust Extraction Adaptor with WARNING: To reduce the risk of serious personal Plunge Cutting Accessory (Fig.
English Protecting the Environment Separate collection. Products and batteries marked with this symbol must not be disposed of with Cleaning normal household waste. WARNING: Blow dirt and dust out of the main housing Products and batteries contain materials that with dry air as often as dirt is seen collecting in and around can be recovered or recycled reducing the demand for raw the air vents.
Page 20
Belgique et WALT ‑ Belgium BVBA Tel: NL 32 15 47 37 63 www.dewalt.be luxembourg België en luxemburg Egide Walschaertsstraat 16 Tel: FR 32 15 47 37 64 enduser.BE@SBDinc.com 2800 Mechelen Fax: 32 15 47 37 99 Danmark WALT (Stanley Black&Decker AS)
Need help?
Do you have a question about the DCS353N-XJ and is the answer not in the manual?
Questions and answers