Page 1
Assembly & Care Assembly Instructions: Step 1 – Remove the three thumb screws and set aside the collector dish. Step 2 - Thread an omnidirectional lavaliere microphone through the center hole of the aluminum plate. Place the microphone cable on the lower support arm, then rotate the upper support arm down against the lower one, capturing the cable within the created center hole.
Page 2
Step 4 – Position the microphone at the Focus point by moving the support arms until the center of the pickup pattern is 1-1/8" (1.13"), or 29mm, behind the face of the yoke plate. (You can use the square flange on the bottom of the dish, which is 1-1/8"...
Troubleshooting: If you are having problems getting audio from your Klover MiK 09: 1) Verify that your microphone is facing toward the inside of the dish and located at the focus point.
Page 5
The inside surface of the dish is critical to this product's performance. DO NOT place or store anything inside the dish, or clean the dish with an ammonia- based cleaner.
Need help?
Do you have a question about the MiK 09 and is the answer not in the manual?
Questions and answers