SafeGuard LRA-PBTXA-L-L User Manual

LRA-PBTXA-L User Manual
Helpful Notes
•
When purchased as a kit (LRA-D1000S-L & LRA-D1000-L), the factory may
program the push button to the receiver. These instructions illustrate pairing a push
button with an LRA-compatible receiver. For specific instructions on operating the
receiver, consult the receiver's manual.
•
The push button is outdoor rated.
•
The push button dimensions: 2.5'' L x 1.2'' W x 4.72'' H
•
When triggered (the center push button is pressed), the center halo will illuminate
brightly for approximately 2 seconds.
•
There is no limit to the number of receivers you can pair with a transmitter.
•
An LRA transmitter's range (line of sight) to the receiver is 1,000 ft.
Figure 1
Push Button Battery Installation
*This product contains a coin battery that could be dangerous to children.
Please review the warnings at the end of this manual regarding the batteries.
Low Battery Indicator
During regular operation, if you notice the red LED under the strobe lens (see
receiver user manual) tends to stay on after the strobe flashes, this indicates you
need to change the battery in a transmitter programmed to the receiver.
Installing/Replacing the Battery
1. Turn over the push button so the mounting plate faces you (see Figure 2).
2. Use your finger to unlock the lock lever on the back mounting plate.
3. Rotate the mounting bracket 90 degrees (parallel to the ground).
4. Separate the mounting bracket from the rest of the unit.
5. Using a coin, rotate the battery cover counterclockwise.
6. Insert a CR2032 battery into the battery compartment provided.
7. Replace battery cover. Using a coin, twist it clockwise to lock it into place
8. Place the back mounting plate back onto the rest of the unit at a 90-degree
angle.
1
LRA-PBTXA-L-L User Manual
Twist it clockwise until you feel the mounting plate click into place.
9.
Programming a Transmitter to the Receiver
The push button may already be programmed to the receiver. Ensure the
battery is installed and plug the receiver in—test by pushing the push button.
1. Ensure the battery is installed in the LRA-PBTXA-L push button and that
the receiver you are programming is powered on.
2. Place the receiver in programming mode. Please consult the receiver's user
manual and follow the programming steps.
3. Once the receiver is in programming mode, trigger the push button by
pressing the center button. The green halo should illuminate.
4. The receiver should play a short note, signifying that the push button has
been programmed to the receiver.
5. Follow the instructions on the receiver to exit programming mode.
Mounting the Push Button
The push button may be mounted using the supplies mounting screws or
supplied double-sided mounting tape (see Figure 3). Remove the backplate of
the push button (see Figure 2) and mount it to the wall. The push button then
snaps onto the mounting plate (see Figure 4).
rev.2025
Figure 2
Figure 3