NexiGo 1588 Manual

If you have any problems, please contact us at cs@nexigo.com at any time for further assistance. This product is covered by our industry leading 1-year manufacturer's warranty. Register at nexigo.com/warranty to get a FREE additional 1-year warranty!

CONTACT INFORMATION

Website: www.nexigo.com

Manufacturer: Nexight INC

Email: cs@nexigo.com

Tel: +1(458) 215-6088

Address: 11075 SW 11th St, Beaverton, OR 97005, US

PRODUCT INTRODUCTION

This Wall Mount with Controller Charging Dock is designed to organize your PS5 console and can support both Digital and Disc versions. The included controller charging docks can simultaneously charge two PS5 controllers in ~3 hours. Each controller charging dock comes with a LED indicator to display the charging status at a glance. An orange light indicates that the attached controller is charging. A blue light indicates that the attached controller is fully charged.

PRODUCT OVERVIEW

1. Console Wall Mount
2. Controller Charging Dock
3. Controller Charging Indicators
4. Controller Charging Slots
5. USB-C to USB-C Charging Cable
6. Headset Holder

SPECIFICATIONS

Power Input: DC 5V 3A (Power the charging dock with the provided USB cable).

Power Output: DC 5V 1A for each charging port.

Charging Time: Fully charge two controllers simultaneously in approximately 3 hours.

Charging Indicators:
Orange: Charging
Blue: Fully charged/standby

Note: The PS5 DualSense controller comes with a built-in protective charge limiter. When the unit is charged above 80% capacity and removed from the charger, it will not charge again until it falls back under 80% charge.

WHAT'S IN THE BOX?

Console Wall Mount x1

Headset Holder x1

Controller Charging Dock x1

Screws x4

PS5 Connector Screw x1

Wall Anchors x4

Charging Cable x1

User Manual x1

Charging Dock Connector Screw x2

INSTALLATION GUIDE

Step 1:
Locate the installation slot at the bottom of the controller charging dock and attach the controller charging dock to the wall mount. Then affix the controller charging dock to the mount using the provided charging dock connector screw as shown below.

Step 2:
Position the console wall mount at an appropriate location on the wall and then locate the screw holes in the wall mount. Use a level (NOT INCLUDED), to make sure that the mount is level on the wall. Mark each hole carefully with a pencil or pen to ensure that the item is mounted in the correct location.

Step 3:
Drill a 6mm hole at each mark (Drill and drill bit NOT INCLUDED).

Step 4:
Insert a wall anchor into each hole and hammer in the wall anchors so they are nearly flush with the wall surface (Hammer NOT INCLUDED).

Step 5:
Insert screws into the wall anchors, but do NOT fully insert the screws into the wall. Leave approximately ¼ to ½ of an inch of the screw sticking out of the wall (Screwdriver NOT INCLUDED).

Step 6:
Slide the console wall mount onto the screws, and then slide the items down to ensure they are firmly attached.

Step 7:
Tighten the screws with the screwdriver(not included) to ensure that the console wall mount is firm and secure. The wall mount is ready to use!

Step 8:
Place the PS5 console on the console wall mount and a x the console to the mount using the provided PS5 connector screw.

Step 9:
Insert the USB Type-C connector for the power cable into the power input port of the controller charging dock and insert the other USB Type-C connector into the console.

Step 10:
Your controller charging dock is now ready to charge your PS5 controllers!

NOTES

• SAFETY WARNING: HAZARD-Small Parts-Not intended for children under 5 years of age.
• Power the charging dock with the provided USB cable.
• Other Type-C power supplies may cause charging failure or extended charging duration.
• To ensure the longevity and lifespan of the wall mount do not place any objects other than the console or accessories on the wall mount. Keep this product dry.
• This product cannot be used and/or stored in high humidity conditions.
• When this unit is not in use or when docked controllers are fully charged, it is recommended that you unplug it from the power source.