1. Manuals
  2. Brands
  3. Bad Cat Manuals
  4. Amplifier
  5. Cub V
  6. Owner's manual

Bad Cat Cub V Owner's Manual

Hide thumbs

Advertisement

Table of Contents

Cub V Owner's Manual
Bad Cat Amps, 1030 W 17th Street, Costa Mesa, California 92627
For the latest information go to: www.badcatamps.com. Whilst the information contained herein is correct at the time
of publication, due to our policy of constant improvement and development, Bad Cat Amps reserves the right to alter
specifications without prior notice.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cub V and is the answer not in the manual?

Questions and answers

Related Manuals for Bad Cat Cub V

Summary of Contents for Bad Cat Cub V

  • Page 1 For the latest information go to: www.badcatamps.com. Whilst the information contained herein is correct at the time of publication, due to our policy of constant improvement and development, Bad Cat Amps reserves the right to alter specifications without prior notice.

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. 8.
  • Page 3 Before switching the unit on it is recommended that the unit be allowed to reach room temperature. Unauthorized modification of this equipment is expressly forbidden by Bad Cat Amps. Never push objects of any kind into ventilation slots on the equipment casing. Do not expose this apparatus to rain, liquids, or moisture of any type.
  • Page 4 Always replace damaged fuses with the correct rating and type. Never disconnect the protective mains earth connection. High loudspeaker levels can cause permanent hearing damage. You should therefore avoid the direct vicinity of loudspeakers operating at high levels. Wear hearing protection if continuously exposed to high levels.
  • Page 5 Our users benefit from our passion every time they plug in and crank up their favorite Bad Cat amp. Since we also play what we build, it is truly gratifying for the Bad Cat Team to be a part of bringing each amp to life and welcome you to the Bad Cat den.

  • Page 6: Depth Control

    Front Panel 1. INPUT Plug your guitar in here. Always use a good quality screened guitar cable. 2. VOLUME This controls the overall gain (input volume) of the amplifier's preamp in both the Clean and Overdrive mode. Turning the control clockwise increases the gain and harmonics. 3.

  • Page 7: Power Input

    (This is bypassed when the footswitch is plugged in) 10. MASTER 2 The Cub V amplifier has two independent master volume controls. Like Master 1, this controls the overall amplitude and volume of the amplifier. You can set one Master for rhythm volume and the other for lead solo volumes.

  • Page 8: Speaker Outputs

    5. FOOTSWITCH The supplied 2-button footswitch is connected here. The footswitch enables you to switch between EF86/12AX7 and Master 1 / Master 2. 6. FX LOOP SEND This output jack sends a -10dB low impedance signal to your effects devices, regardless of if it is a pedal, a rack unit, or an entire chain of effects.
  • Page 9 Technical Specifications o Point to Point Hand-Built in Southern California o Custom Hand-wound Bad Cat Transformers o 40 watts via 2 x EL34 tubes o 1 – EF86 Tube o 4 – 12AX7 Tubes o Single Channel o EF86/12AX7 Switchable Modes...

Table of Contents