Solving Problems; Troubleshooting; Beep Codes - Dell INSPIRON P14E Setup Manual

Solving Problems

This section provides troubleshooting
information for your computer. If you cannot
solve your problem using the following
guidelines, see "Using Support Tools" on
page 60 or "Contacting Dell" on page 80.
WARNING: Only trained service
personnel should remove the computer
cover. See the Service Manual at
support.dell.com/manuals for advanced
service instructions.

Beep Codes

Your computer might emit a series of
beeps during start-up if there are errors or
problems. This series of beeps, called a beep
code, identifies a problem. If this occurs,
write down the beep code and contact Dell
(see "Contacting Dell" on page 80) for
assistance.
NOTE: To replace parts, see the Service
Manual at support.dell.com.
54
Beep Possible Problem
Code
One Possible system board failure —
BIOS ROM checksum failure
Two No RAM detected
NOTE: If you installed or replaced
the memory module, ensure that
the memory module is seated
properly.
Three Possible system board failure —
Chipset error
Four RAM read/write failure
Five Real Time Clock failure
Six Video card or chip failure
Seven Processor failure
Eight Display failure