7. Note the two (2) 'key ears' of the High Frequency Voice Coil Assembly
contain Pin Terminals (see Figure 8) which are engaging mating Connectors
located in the Tweeter Magnet (see Figure 9).
8. Carefully insert a wide, thin Scraper (or wide, thin Screw Driver) between the
Tweeter Magnet and the High Frequency Voice Coil's Plastic Base near the
Pin Terminals.
9. Gently rock the Scraper to apply an upward force (away from Magnet) to
disengage and lift the High Frequency Voice Coil's Pin Terminal from its
mating Connector.
10. Repeat Steps 8 and 9 on the opposite side of the High Frequency Voice Coil's
Plastic Base to disengage the second Pin Terminal.
11. Note Pin Terminals may not disengage without breaking, see Figures 8 and 9.
Figure 7
Page 5 of 11