RinseKit models. Additional Information When combined with the PRO, Cube, Rack or Tailgate Shower, the HyperHeater 2.0 can heat water up to 110 F in less than Storage 30 seconds, so you can have a steaming hot shower in seconds.
Parts and Accessories Parts and Accessories hanger mount water hose gas hose flame window water temperature water pressure water temperature gas adapter display battery door gas inlet tap outlet water inlet shower head & suction hanger metal stand (x2)
Page 4
(if adapter is needed). tube slots on rear panel. Connect the gas hose to the gas inlet on the HyperHeater 2.0 (brass connection) by pulling the sleeve on the hose end down, Turn and snap into stand locks on then pushing it directly into the bottom of base.
We recommend using 16oz consumer grade propane tanks to The heater only ignites if the dial operate the HyperHeater 2.0. is in the blue highlighted section. This system also works with a higher pressure home water hose.
Check that the water is not over temperature Problem: Disconnect the RinseKit and Water is not hot enough shower head. Dump out any water by tilting the RinseKit and turning Cause: the release valve Check gas control counterclockwise to open.
Important Safety Warnings Contact PHONE : 800-613-5764 EMAIL : info@rinsekit.com Your HyperHeater 2.0 comes with a warranty. For more information, visit the Warranty Tab at www.rinsekit.com. (Proof of purchase is required for warranty claims) Connect Don’t forget to tag us for a chance to be featured on our social media.
Need help?
Do you have a question about the HYPERHEATER 2.0 and is the answer not in the manual?
Questions and answers