Page 3
Attach gas regulator to back of gas regulator. the heater. Propane NOT included. Connect propane power cord Connect power cord into RinseKit into power inlet. PRO 12v outlet. NOTE: (You can also plug into vehicle 12v outlets) See next page...
Page 4
Remove nozzle from your RinseKit Connect included heater shower and connect to the water inlet via head to tap outlet. Make sure the quick connect. Make sure the valve is in the ON position. valve is in the ON position.
Page 5
IMPORTANT INFORMATION We recommend using 16oz consumer grade propane tanks to operate the HyperHeater. For the optimal shower temperature, start with the gas valve in the center between LOW and HIGH. Adjust temperature as needed. IMPORTANT: ⚠ Remember to disconnect the...
ADDITIONAL INFORMATION When you shut off the nozzle, the hot water inside the heater may cause the cut out light to illuminate. Keep shower nozzle in ON position during use. Turning the nozzle OFF and ON repeatedly will cause overheating and will trigger cut out warning.
Page 7
Disconnect the propane from the regulator. Disconnect the RinseKit and the shower head then dump out any water left inside the heater by tipping the heater backwards. Never store the heater on its side.
CUSTOMER SERVICES For questions and assistance: 800-613-5764 | info@RinseKit.com | RinseKit.com Your HyperHeater comes with a warranty. For more information, visit the Warranty Tab at www.RinseKit.com. *Proof of purchase is required for warranty claims. CONNECT WITH US Don't forget to tag us on social media for a chance to be featured on our RinseKit in Action page! Use #RinseKit when sharing your post.
Need help?
Do you have a question about the HYPERHEATER and is the answer not in the manual?
Questions and answers