1. Manuals
  2. Brands
  3. Kurt Manuals
  4. Crimp tool
  5. KH16P
  6. Operating instructions manual

Kurt KH16P Operating Instructions Manual

Portable hose crimping machine
Hide thumbs

Advertisement

Table of Contents

KH16P PORTABLE HOSE
CRIMPING MACHINE
Operating Instruction Manual
ENGLISH

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KH16P and is the answer not in the manual?

Questions and answers

Related Manuals for Kurt KH16P

Summary of Contents for Kurt KH16P

  • Page 1 KH16P PORTABLE HOSE CRIMPING MACHINE Operating Instruction Manual ENGLISH...

  • Page 2: Table Of Contents

    Maintenance / Warranty ..................................6-7 Contact Information ....................................8 IN THE BOX TECHNICAL DATA • Crimper DIE SET PART NO. Model KH16P Ø8 die set KM92SAD-8 Crimp range Ø6 - Ø25 4SH (1/4" to 1" hose) • 9 Volt battery Ø12 die set KM92SAD-12...

  • Page 3: Introduction

    INTRODUCTION 2. Manual hydraulic pump The Kurt Hydraulics KH16P Crimper is part of our new product series. Featuring 12. Hose assembly maximum on-the-fly portability and 10. Pressure release valve flexibility with a hydraulic hand pump, 11. Oil fill cap 7 die sets, and the capacity to crimp hoses 1/4 inch to 1 inch in diameter.

  • Page 4: Initial Crimper Setup

    INITIAL CRIMPER SETUP Always follow manufacturer 1. Assemble base and pump: The KH16P is a portable crimp specs. CAUTION crimper and designed to be used in a variety of places and operating conditions. Unbox and assemble 3. System pressure: Pressure is set at the factory and crimper and pump and operate it in a dry, well- should not be adjusted.

  • Page 5: Installing And Removing Die Sets

    INSTALLING AND REMOVING DIE SETS Step 1: Select the correct die. Always use manufacturer crimp Step 2: Die shoes are slotted. Make sure crimper and die shoes are specifications. See machine set up instructions on page 4. lubricated with lithium grease. Dies should easily slide into die shoes. Step 3: Slide each die into one of the 8 slots - position dies with Step 4: With all dies inserted, hose assembly can be crimped.

  • Page 6: Maintenance / Warranty

    1. Regularly check for loose the fittings and/or hardware on crimper. Tighten or replace as needed. WARRANTY he Kurt KH16P Crimper is warranted to be free from defects in material and workmanship under normal operating conditions and recommended usage for a period of 1 year from date of delivery. Any product which is shown to be defective shall be replaced or repaired free of charge or extended a credit refund of the original acquisition cost to the purchaser.
  • Page 7 MAINTENANCE (EVERY 3 MONTHS) 8 mm hex bolts 6 mm wrench Lubricate die shoes Regularly retorque hex bolts on the front of the head unit to 25 ft-lb Apply lithium grease around the inside of the crimp head to lubricate ±6 ft-lb.

  • Page 8: Contact Information

    Thank you for your purchase! If you have any feedback or questions please contact us: Kurt Hydraulics // A Division Of Kurt Manufacturing 302 Jeffers Avenue, Lyman, NE 69352 Phone 308-787-0127 | Toll Free: 866-257-7995 Fax 308-787-1281 Manual Version: kurthydraulics.com | hydraulicsales@kurt.com...

Table of Contents