TEFAL Freemove Power User Manual
Hide thumbs
Also See for Freemove Power:
- User manual (20 pages) ,
- Quick start manual (2 pages) ,
- Manual (98 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for TEFAL Freemove Power
Summary of Contents for TEFAL Freemove Power
- Page 1 FREEMOVE POWER www.tefal.co.uk...
- Page 2 STEAM BOOST www.tefal.co.uk...
-
Page 3: Table Of Contents
Important safety recommendations SUMMARY • Please read these instructions carefully before first use. This product has been designed for domestic and IMPORTANT SAFETY RECOMMENDATIONS indoor use only. Any commercial use, inappropriate Important safety recommendations ............p. 5 use or failure to comply with the instructions, the Before first use .................... - Page 4 mental capacities provided that they have been The iron must always be placed on its base and never on its heel (for cordless irons) thoroughly instructed regarding use of the appliance, • Your iron and its base must be used and placed on a stable surface. When you place the iron on its base, ensure that the surface on which the base is placed is stable.
-
Page 5: Before First Use
BEFORE FIRST USE PREPARATION Which water should I use? Remove any labels from the soleplate before heating the iron. • Your appliance has been designed to function using untreated tap water. However, the steam chamber auto-clean should be run regularly in order to remove limescale. If your water is very hard Before using the steam function in your iron for (hardness above 30°f or 17°dH or 21°e), we recommend you use a the first time, we recommend that you allow the... -
Page 6: Use
• Plug in the base. • Take the iron from the base to iron Click • Make sure to hear the click when putting the iron back on the base • The flashing green light located on the base indicates that the iron is heating up. -
Page 7: Adjusting The Temperature And Steam
Adjusting the temperature and steam • Adjust the temperature and steam control, referring to the table below. • The flashing green light located on the base indicates that the iron is recharging (around 11 seconds). • When the green light stops flashing the iron is ready to use. TEMPERATURE STEAM CONTROL FABRIC... -
Page 8: Extra Steam Position
Extra steam position • Your iron heats up quickly: start with fabrics that are ironed at a low temperature and finish with those that require a higher temperature. • If you lower the thermostat temperature, place the iron on its base and wait (around 10 minutes) until the temperature drops to avoid burning the fabric. -
Page 9: Vertical Steam Ironing
Vertical steam ironing • Frequently re-heat your iron on the base • Hang the item on a hanger. The steam is very hot; never • Make sure to hear the click when putting back the iron on the steam iron clothing while it is being worn - always use a hanger. -
Page 10: Dampening Clothing (Spray)
Dampening clothing (Spray) IRON STORAGE AND MAINTENANCE Storing your iron • Press repeatedly on the spray button to moisten clothing and remove stubborn creases. • Ensure that there is water in the tank before using the spray button. • Unplug the iron and wait for the soleplate to cool (1 hour ). While ironing •... -
Page 11: Auto Off
4 h . • Carry the iron by the handle thanks to the carry lock • Soak the valve for 4 hours in a glass of water with lemon juice or citric acid. Auto off • The electronic system cuts off power after 8 minutes of none use. 8 min. -
Page 12: Cleaning The Soleplate
Cleaning the soleplate • Shake the iron gently and in a horizontal position, • Wait 1h to clean the soleplate with a damp cloth over the sink, until some of the water (and the impurities) have drained through the soleplate. Click •... -
Page 13: Is There A Problem With Your Iron
Periodically vacuum the holes in the www.tefal.co.uk soleplate. The soleplate is The temperature of the iron is Consult the chapter " adjusting dirty or brown too hot. - Page 15 1820014287 - 16/24 - FMP2...
Need help?
Do you have a question about the Freemove Power and is the answer not in the manual?
Questions and answers