Page 1
Broiler area must be kept free of combustible materials, and the flow of combustion and ventilation air must not be obstructed. Operating personnel must not perform any maintenance or repair functions. Contact your Nieco Authorized Dealer. IMPORTANT: RETAIN THIS MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE...
Keep these instructions for future reference. If the unit changes ownership, be sure this manual accompanies the equipment. IMPoRTanT The nieco Corporation reserves the right to change specifications and product design. such revi- sions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
Authorized Nieco Distributors and Service Agencies will void the warranty and may significantly alter the performance of your broiler. The use of non-Nieco parts is capable of affecting these criteria, and may affect broiler performance, parts longevity and food safety. Your local Authorized Nieco Distributor and Service Agent has been factory trained and has a complete supply of parts for your Nieco Automatic Broiler.
Page 6
Distributor for adjustment or repair. • Use only genuine Nieco replacement parts for your broiler. Failure to do so will void the warranty and may significantly alter the performance of your broiler. The use of non-Nieco parts is capable of affecting these criteria, and may affect broiler performance, parts longevity and food safety.
For easy movement of the appliance, the connector should be installed with a "lazy" loop for minimum tension. note: Gas appliances should be disconnected prior to maximum movement. (Minimal movement is possible to connect hose.) Nieco Corporation - Model JF63/63-2G...
Disconnect power before servicing. b.10 Pre-operation Check Be sure that all parts are installed in the proper location: Ventilation is turned on Broiler is plugged in Gas line is connected Nieco Corporation - Model JF63/63-2G...
3.Main On/Off Switch - Turns the broiler on and off. 4.Ignition Failure Light - If flashing, indicates the broiler is no longer lit. 5.Power Indicator Light - Glows green when the power to the broiler is on. Nieco Corporation - Model JF63/63-2G...
Page 11
4. SELECTION INDICATOR LIGHT - Lights up to show which button is selected. on THe baCK of THe bRoIleR a. Belt Reverse Buttons - In the event the broiler gets jammed, use these buttons to reverse the direction of the meat belt to help clear the jam.equipped). Nieco Corporation - Model JF63/63-2G...
If this still doesn’t light the broiler, see the MANUAL IGNITION instructions. 1. Turn the MaIn PoWeR sWITCH on. 2. Allow broiler to heat for 45 minutes before cooking. Nieco Corporation - Model JF63/63-2G...
Your Nieco Automatic Broiler is designed to automatically stop gas flow to the broiler in the event of power failure, gas pressure loss or any other related incident. No attempt to operate this appliance should be made in the event of a power failure.
After an hour, push the down arrow to lower Do not cook during the set point to 25º ABOVE the actual calibration. temperature. The numbers on your c. Your broiler is now calibrated. broiler will be different than those shown here. Nieco Corporation - Model JF63/JF63-2...
Page 15
(10 character limit). Press and hold the PRODUCT SELEC- TION BUTTON for 5 seconds to save the changes and return to normal operation. Nieco Corporation - Model JF63/63-2G...
Picture of the part to be removed and cleaned. How to remove and Instructions clean the parts. Pull each meat guide out slightly from the bottom, then lift off. Wash, rinse, and sanitize in the 3-compartment sink. Nieco Corporation - Model JF63/63-2G...
Page 17
Meat Guide (If equipped) Clean: Every 4 hours Feed End Tools Scrub Pad 3-Compartment Sink Instructions 1. Lift the meat guides up and off the feeder. 2. Wash, rinse, and sanitize in the 3-compartment sink. Nieco Corporation - Model JF63/63-2G...
Page 18
3. Wash, rinse, and sanitize in the 3-compartment sink. DO NOT lift the feeder base by the feeder bar or the chains. This will damage the feeder base. REASSEMBLY: Pull the release pin and place feeder base in position. Nieco Corporation - Model JF63/63-2G...
Page 19
REASSEMBLY: Pull the release pin and place feeder base in position. Feeder Housing Clean: Daily Feed End Tools Scrub Pad 3-Compartment Sink Instructions 1. Lift and remove. 2. Wash, rinse, and sanitize in the 3-compartment sink. REASSEMBLY: Hang feeder housing on brackets. Nieco Corporation - Model JF63/63-2G...
Page 20
Heat Resistant Gloves Degreaser 3-Compartment Sink Instructions 1. Lift and slide bracket out. 2. Take to sink area and spray with degreaser. 3. Wash with a scrub pad, rinse, and sanitize in the 3-compartment sink. Nieco Corporation - Model JF63/63-2G...
Page 21
Soapy Towel Sanitized Towel Instructions 1. Clean product holding area while still warm. 2. Wring out a soapy towel and wash product holding area. 3. Wring out a sanitized towel and wipe product holding area. Nieco Corporation - Model JF63/63-2G...
Page 22
1. Tilt and lift pins off hooks; lift off. 2. Take to sink area and spray with degreaser. 3. Wash, rinse, and sanitize in the 3-compartment sink. REASSEMBLY: Make sure pan inserts are on and return pan hangs on brackets. Nieco Corporation - Model JF63/63-2G...
Page 23
Heat Resistant Gloves Degreaser 3-Compartment Sink Instructions 1. Lift and remove the grease box. 2. Take to sink area and spray with degreaser. 3. Wash with a scrub pad, rinse, and sanitize in the 3-compartment sink. Nieco Corporation - Model JF63/63-2G...
Page 24
3. If necessary, use a stiff toothbrush to clean any clogged burner holes. REASSEMBLY: Be sure the holes on the burner are facing up. Burners must be completely dry before reassembly. Dry with a paper towel. Nieco Corporation - Model JF63/63-2G...
Page 25
EXTREMELY HOT! Be careful not to burn yourself. 1. Lift cap from shroud collar. 2. Take to sink area and spray with degreaser. 3. Wash with a scrub pad, rinse, and sanitize in the CAUTION: 3-compartment sink. Extremely Hot Nieco Corporation - Model JF63/63-2G...
Page 26
1. Lift air upper burner and air box from the top of the broiler. It is not necessary to detach them. 2. Use a stiff brush to clean any clogged burner holes. Be sure that both air box assemblies are installed and sit flush on their brackets. Nieco Corporation - Model JF63/63-2G...
Page 27
2. Remove the ceramic boot from the back of the flame sensor. 3. Loosen the wing nut holding the flame sensor in place. 4. Remove the flame sensor and clean the metal tip with a DRY, clean scrub pad. Nieco Corporation - Model JF63/63-2G...
Page 28
1. Scrape each shaft of both belts on the discharge end with the wide end of the shaft cleaning tool. The tool is located on the clip on the discharge end of the broiler. 2. Wipe shaft cleaning tool with a towel. Nieco Corporation - Model JF63/63-2G...
Check cookout temperature (undercooking). CooKInG PRobleMs Burgers under or over cooked. Adjust conveyor belt speed. Clean burners and orifices. Excessive flaming in broiler. Clean the catalyst if equipped. Check the hood for proper operation. Check product for overcooking. Nieco Corporation - Model JF63/63-2G...
G. WIRInG DIaGRaM H i gh Pr essur e B l ow er M ot or R ever se Sw i t ch P/ N 18447 P/ N 13579 Nieco Corporation - Model JF63/63-2G...
Page 36
G. WIRInG DIaGRaM H i gh Pr essur e B l ow er M ot or R ever se Sw i t ch P/ N 18447 P/ N 13579 Nieco Corporation - Model JF63/63-2G...
Page 37
G. WIRInG DIaGRaM - MUlTI-PRoDUCT ConTRol H i gh Pr essur e B l ow er M ot or R ever se Sw i t ch P/ N 18447 P/ N 13579 Nieco Corporation - Model JF63/63-2G...
Page 38
G. WIRInG DIaGRaM - MUlTI-PRoDUCT ConTRol Nieco Corporation - Model JF63/63-2G...
CaUTIon Do not operate the broiler at gas pressures other than those stated here. Doing so will affect the opera- tion of your broiler. Nieco Corporation - Model JF63/63-2G...
Need help?
Do you have a question about the BroilVection JF63-2 and is the answer not in the manual?
Questions and answers