Advertisement
Temperature Sensor (outdoor)
Instruction manual version 20210530
The document contains information on the safety, installation, and use of the AURATON Temperature
Sensor.
Description of the device
The AURATON Temperature Sensor indoor is a temperature sensor with a measurement resolution of
0.1 °C for use inside buildings. It is a battery-powered device that ensures uninterrupted operation for
up to 2 years. It is designed for use with the AURATON Pulse control panel.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AURATON Smart Temperature Sensor
Summary of Contents for AURATON Smart Temperature Sensor
- Page 1 The AURATON Temperature Sensor indoor is a temperature sensor with a measurement resolution of 0.1 °C for use inside buildings. It is a battery-powered device that ensures uninterrupted operation for up to 2 years. It is designed for use with the AURATON Pulse control panel.
-
Page 2: Device Installation
Back indicator LED temperature sensor holes for the mounting bracket pairing button Device installation... - Page 3 Drill two holes with a diameter of 5 mm into the wall (measure the spacing between the holes using the mounting bracket – included in the set with the device). Insert the wall plugs (included). Insert the holder into the silicone gasket. Screw the mounting bracket with the gasket on to the wall.
-
Page 4: Battery Replacement
Battery replacement If the battery in the device is discharged, replace it with a new type CR2032 3 V battery. To do this, unscrew the 4 screws securing the back cover of the housing. Then remove the plate located at the bottom of the housing and using a flat screwdriver remove the battery located in the battery compartment. -
Page 7: Device Functions
Device functions Device: measures room temperature with a resolution of 0.1 degree, works up to 2 years on one battery, equipped with a replaceable CR2032 3V battery, indicates its operation by means of a two-colour LED, establishes a secure radio connection with other devices using the AURA protocol. Description of the measured parameters: Temperature –... - Page 8 Activating pairing – AURATON Pulse control panel Pairing in AURATON Pulse is enabled using the AURATON Smart App. On the next screen, name the device you are adding. After entering the name, press the “Add” button. Once paired correctly, you...
-
Page 9: Factory Reset
Factory reset In order to restore the factory settings, during normal operation of the device, hold down the function button (approx. 5s) until the LED lights up red. Then release the button and press it again within 3 seconds to confirm the operation. All information on the device will be cleared. - Page 10 Control from the level of the AURATON Smart application From the AURATON Smart application level, it is possible to view the current temperature and battery level expressed in percent.
-
Page 11: Restoring The Previous Software Version
Restoring the previous software version After performing an update or in the case of its failure, it is possible to restore the previous software version. -
Page 12: Technical Specifications
The user shall return it to a collection point for electrical and electronic waste. Hereby, LARS Andrzej Szymanski declares that the radio equipment type AURATON Pavo is in compliance with Directive 2014/53/EU and 2011/65/EU. The full text of the EU declaration of... - Page 13 Contact and address of the manufacturer: LARS, ul. Świerkowa 14 64-320 Niepruszewo www.auraton.pl Download User manual Declaration of conformity...
Need help?
Do you have a question about the Smart Temperature Sensor and is the answer not in the manual?
Questions and answers