Related Manuals for EXEL E Series
Summary of Contents for EXEL E Series
- Page 1 Operation Manual Version 2.0 E Series E-6, E-8, E-10, E-12, E-15 ESW-110, ESW-115, ESW-118 Keep these important operating instructions. Check www.tecnare.com for updates.
- Page 3 Exel Acoustics SL accepts no responsibility for any errors or inaccuracies that may appear in this manual or the products and software described in it. Technical specifications, dimensions, weights and properties do not represent guaranteed qualities.
-
Page 4: Important Safe Instructions
When a cart is used, use caution when moving the cart / apparatus combination to avoid injury from tip-over. If the equipment is used in a manner not specified by the Exel Acoustic, the protection by the equipment may be impaired. Read entire... -
Page 5: Symbols Used
Information doit être Instructions complémentaire strictement instructions Suivi Wichtige Pflicht. Diese Betriebsanweisung Informationen. Anweisungen oder Zusätzliche müssen strikt Gebrauchsanleitung Informationen befolgt sanleitung Obligación. Estas instrucciones Importantes Información deben ser instrucciones operativas complementaria estrictamente seguidas 2.01 www.tecnare.com E Series | rev. -
Page 6: Declaración De Conformidad
España (Spain). Declara que los productos E Series y sus respectivas opciones, cumple con las Directivas: Declare under our sole responsibility that devices in the E Series range of products, comply with relating Directives: (1) Directiva de Baja Tensión - 2006/95/CE (2) Directiva de Compatibilidad Electromagnética - 2004/108/CE... -
Page 7: Table Of Contents
DECLARACIÓN DE CONFORMIDAD ..................5 Introduction ........................7 Welcome to Tecnare ....................7 Overview ........................8 The E Series Loudspeaker ..................9 Connections ......................12 Loudspeakers Configurations ..................14 Processing and Amplification .................. 13 Full Range Stereo/Parallel configuration ..............14 Full Range with low-frequency element.............. -
Page 8: Introduction
If you would like further information about this or any other Tecnare product, please contact us. We look forward to helping you in the near future. As part of a continuous evolution of techniques and standards, Exel Acoustics ® SL as manufacturer of Tecnare products reserve the right to change the specifications of its products and the content of its documents without prior notice. -
Page 9: Overview
Custom built, industry leading Tecnare transducers and enclosures give E SERIES the power and ruggedness to stand up to a variety of demanding applications and provide reliable, highest quality sound wherever it is needed. -
Page 10: The E Series Loudspeaker
Operation Manual The E Series Loudspeaker FEATURES The Tecnare E6 loudspeakers are comprised of: • One 6,5-inch driver • One 1-inch HF compression driver. • Built-in rigging points (eyebolt) The E-6 is a ultra-compact 2-way passive loudspeaker that used a 6.5” low-mid frequency transducer in a bass-reflex cabinet and an 1”... - Page 11 One 10-inch driver • Ultra-compact enclosure • Built-in rigging points (eyebolt) • Sonic impact precision ESW-110 ultra-compact subwoofer system that incorporates an 18” transducer in a bass-reflex cabinet. Two recessed handles makes moving easy. 2.01 www.tecnare.com E Series | rev.
- Page 12 Top located pole mount socket The ESW-118 is a vented-box that used a 18” frequency transducer. rectangular cabinet is fitted with M10 threaded suspension points. located pole-mount socket permits mounting full-range systems above ESW- 118. 2.01 www.tecnare.com E Series | rev.
-
Page 13: Connections
SpeakON connectors. There are two NLT4 ® connectors on the rear of each E Series enclosure. These connectors mate with Neutrik NL-4 or NL-4 compatible in-line cable connectors. The pins 1+/1- of both connectors are wired in parallel to link multiple loudspeakers on a single amplifier output. Remember that parallel connection reduces the total impedance (Ω) seen by the amplifier. -
Page 14: Processing And Amplification
- Thermal protection from power surges or overload - Xmax Excursion displacement protection The T20-44 amplifier is the ideal companion for maximum performance of the E Series loudspeakers. This amplifier controller with DSP offer a complete both preset and protection solution for any application. -
Page 15: 1.5 Loudspeakers Configurations
Each enclosure type is driven by the PA Series amplifier according the cabinet power requirements. Correct factory preset is needed. Connect each one of the subwoofers to the two outputs of the amplifier and consequently, connecting the Full Range cabinets to a second amplifier. 2.01 www.tecnare.com E Series | rev. -
Page 16: Recommended Amplifier Power
Damping factor is a ratio of rated loudspeaker impedance (ZL) to the source impedance (Zs). In this case our source impedance is (Rcable + Ramplifier). Damping Factor = Z Recommended maximun length 8 Ω 4 Ω 2 Ω cable cross-section mm² 2.01 www.tecnare.com E Series | rev. -
Page 17: Flying And Suspension
Operation Manual Flying and Suspension Tecnare E series offers 4 kind optional accessories for suspendable: BR U-Bracket, HG1 Wall and Truss Bracket, HG2 Ceiling Bracket and TSC-350 Wall Mount. Before attempting to suspend your speakers, read and understand the following safety information. -
Page 18: Tripod Use
The BR is an optional accessory for wall mounting mainly for horizontal placement. Please, refer to BR operation manual to get more information. 3.4.2 HG1 Wall and Truss Bracket It is a rigging bar for flying all the E Series Loudspeaker. The rigging system consists of four screws around the bar. 2.01 www.tecnare.com... - Page 19 3.4.3 Flying with Eyebolts E Series loudspeakers feature several internal steel angles, with 2 mounting threads each. This angle provides different flying points. Eyebolt flying points are factory sealed with M6, M8 and M10 screws, which are replacement with eyebolt on the flying points as required. It is specially recommended for fixes d installations where the boxes are permanently fixed.
-
Page 20: Technical Specifications
Eye bolt TSC-350 Application information is presented for guidance only. Exel Acoustics SL reserves the right to make any necessary changes to the products and the published specifications. As part of the ongoing development program Exel Acoustics SL tries to maintain the highest degree of product compatibility. - Page 21 Operation Manual 2.01 www.tecnare.com E Series | rev.
- Page 22 The contents of this manual are furnished for informational purposes only, are subject to change without notice, and should not be construed as a commitment by Exel Acoustics SL. Exel Acoustics assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual. Except as permitted by applicable copyright law, no part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, recording or otherwise, without prior written permission from Exel Acoustics.
- Page 23 EXEL ACOUSTICS SL CL Encinar, 282 - Pol. Ind. Monte Boyal 45950 Casarrubios del Monte (To) Spain support@tecnare.com www.tecnare.com - www.facebok.com/tecnare (T): +34 918 170 110 - +34 918 171 001 (F): +34 918 183 053 rev.:2.01 2017...
Need help?
Do you have a question about the E Series and is the answer not in the manual?
Questions and answers