Babies R' Us no more chills Bather User Manual

no more chills
™
Bather
User Guide 3918135
• Please read the following instructions and warnings carefully.
• Keep these instructions for future reference.
• Tool needed: Phillips Head Screwdriver (not included).
• 4 AA batteries (not included).
• For use with children from birth until sitting up unassisted.
Features & Components
Bather Frame and Fabric Cover
Clip-on
Bather Legs (2)
Heating Unit
(requires 4 AA batteries,
not included)
Important Safety Warnings
WARNING! FOR INFANTS ONLY
• Infants have DROWNED in infant bath tubs.
• ALWAYS keep infant within adult's reach.
• NEVER lift the bather with child in it.
• NEVER leave infant unattended.
• NEVER place this product in an adult tub or sink filled with water.
• ALWAYS keep the drain open in the adult tub or sink.
• DO NOT place this product on any elevated surface.
• DO NOT submerge the battery, cord or heating element in water or any liquid.
• Infants can drown in as little as 1 inch (2.5 cm) of water.
• ALWAYS bathe your infant using as little water as necessary.
Set-up and Use of your Bather
Please check the following before each use: • Feet are securely locked into bather frame.
• Ensure fabric cover and heating unit are secured into position.
• Discontinue use of product if damaged, broken, or disassembled.
To assemble:
knotches for headrest
recline position
1 Unfold footrest until it snaps into place. 5 Install batteries into clip-on heating unit
(see below) and slide heating strip into pocket
2 Unfold headrest and snap into place in
on bath sling.
the desired position.
Clip heating unit onto bath sling to secure in place.
Note: Battery door must face back of bath sling.
Battery Installation:
• Remove the battery compartment cover
from the clip-on heating unit.
• Insert 4 AA batteries (not included).
Make sure batteries align properly to the
correct positive "+" and negative "-"
polarity marked in the battery compartment.
• Replace the battery compartment cover
and tighten.
3 Pivot the support legs out until they rest into place.
4 Insert bather leg into foot until each side snaps
into place. Repeat for other foot.
Care and Maintenance
Cleaning
• Fabric Cover: Remove heating unit from fabric cover and fabric cover from frame.
Secure hook and loop closures before washing. Machine wash warm, gentle cycle.
Do not bleach. Hang to dry. Frame: Wipe with a damp cloth and mild soap.
• NEVER allow other children to substitute for adult supervision.
• ALWAYS check water temperature before placing child into tub.
• Bath water temperature for bathing a baby should be between
90˚F and 100˚F (32.2˚C and 37.8˚C).
• Discontinue use of the product if it becomes damaged, broken,
or disassembled.
• This product is not a toy. DO NOT allow children to play with it.
• Maximum weight of infant = 25 lbs.
• For use until infant can sit up unassisted.
To adjust recline position:
1 Firmly grasp headrest frame on each side of
bather, and pull out to reposition headrest into
lower recline slot on bather knuckle.
WARNING: Never adjust recline position
with baby in bather.
To use heating unit:
1 Press the On/Off button on
top of the unit. The red LED
will illuminate, indicating
that the unit is warming.
2 The unit will automatically
switch off after approximately 10 minutes.
3 To turn the unit off before it is done warming,
press the On/Off Button.
WARNING!
• ONLY use as intended.
• DO NOT use on its own or with other products.
Storage
• Allow the heating unit to cool. Remove batteries before storing.
• Wipe fabric cover and frame down with a dry cloth before storing.
• Store out of reach of children in a safe, dry location.
Battery Installation & Use
BATTERY WARNING!
• ALWAYS keep batteries away from children.
• Any battery may leak if mixed with a different battery type, installed
incorrectly or if all batteries are not replaced or recharged at the same time.
Never mix old and new batteries. Never mix battery types such as alkaline,
standard (carbon-zinc) or rechargeable (nickel cadmium).
• Any battery may leak or explode if discarded or if an attempt is made to
charge a battery not intended to be recharged.
• Discard leaky batteries immediately to avoid skin burns or other personal
injury. Discard batteries properly according to local regulations.
• ALWAYS remove batteries if you do not intend to use the product for an
extended period of time. Batteries left in the unit may leak and cause damage.
• Alkaline disposable batteries are recommended. Never mix battery types.
Change batteries when unit no longer functions properly.
Helpful Hints
How warm does the heating unit get?
The warming unit is designed to safely keep your baby warm during bath time
and will heat to approximately 90˚F.
Is it okay for the heating unit to get wet?
The heating unit is designed to be battery operated and water safe, although we do not
recommend submerging the unit itself under water. The heating strip, which is inserted into
the pocket on the back of the bath sling is waterproof and can get wet during bath time.
Will I need to replace the warming unit and strip at any point?
The heating unit, if used properly, should not be required to be replaced. However,
if the unit does not work properly after batteries have been replaced, please contact our
Consumer Care Team.
Troubleshooting
Problem Solution
Fabric cover is not Make sure batteries are installed correctly and heating
getting warm unit is secured properly
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Consumer Support
Baby's Journey stands behind all of its products. If you are not completely satisfied
or have questions, please contact our Consumer Care Team at 1-855-422-2975 or
email us at wecare@babysjourney.com.
For replacement parts information or questions, please visit www.babysjourney.com.
BABIES "R" US is a mark of (est une marque de/é uma marca de) Geoffrey, LLC and Toys "R" Us (Canada)
Ltd. (ltée). © 2012 Geoffrey, LLC. Made in China (Fabriqué en Chine/Hecho en China). Distributed in the
United States by (Distribué aux États-Unis par/Distribuído nos Estados Unidos por) Toys "R" Us, Inc.,
Wayne, NJ 07470. Imported in Canada by (Importé par/Importado no Canadá por) by Toys "R Us (Canada)
Ltd. (ltée), 2777 Langstaff Road, Concord ON L4K 4M5. Imported in Australia by Toys "R" Us (Importé par/
Importado na Austrália por) Pty Ltd., Regents Park NSW 2143
WWW.BABIESRUS.COM 11/20/12